HP Color LaserJet Enterprise 5700, 6700, 6701, X557, X55745, X654, X65455, X65465, MFP 5800, 6800, 6801, X57945, X58045, X677, X67755, X67765 - Install the optional printer stand with storage

Follow these steps to install the optional printer stand with storage.

1. Verify that the box for the optional printer stand includes the following items:

   • Installation instructions leaflet

   • Printer stand with storage

   • Stabilizer feet (4)

   Contents of the box

   

2. Press the Power button to turn off the printer, and then disconnect the power cord from the back of the printer.

   Turn off the printer and disconnect the power cord

   

3. Disconnect the USB or network cable and the phone cable for the fax (if applicable) from the rear of the printer.

   Disconnect the cables

   

4. Place the printer stand with storage on the floor in the location where the printer will reside, and then engage the locks on the wheels to prevent the stand from rolling.

   Lock wheels on printer stand

   

5. Place the printer on top of the printer stand. Use the alignment pins to position the printer on the stand.

   Note:

   HP recommends that two people move the printer to place it on top of the printer stand.

   Place the printer on the stand

   

6. Open the door on the front of the printer stand (callout 1), and inside the storage compartment on the top-right side, rotate the lever to the right to lock the printer to the stand (callout 2).

   Lock the printer stand to the printer

   

7. Close the door on the front of the printer stand.

8. Install the four stabilizer feet on the bottom corners of the printer stand and make sure they fit securely in the slots.

   Install the stabilizer feet

   

9. Reconnect the USB or network cable and the phone cord for fax (if applicable) to the rear of the printer.

   Reconnect the cables

   

10. Reconnect the power cord to the rear of the printer, and then press the Power button to turn on the printer.

    Reconnect the power cord and turn on printer