The following information describes how to load paper in Tray 1.
caution:To avoid jams, never add or remove paper from Tray 1 during printing.
-
Open Tray 1.Figure : Open Tray 1
-
Pull out the tray extension to support the paper.Figure : Pull out the tray extension
-
Load paper in the tray. For information about how to orient the paper, see Tray 1 paper orientation.Figure : Load paper
-
Make sure that the paper fits under the fill line on the paper guides.
note:
The maximum stack height is 10 mm, or approximately 100 sheets of 75g paper.Figure : Stack-height limit -
Adjust the side guides so that they lightly touch the paper stack, but do not bend it.Figure : Adjust the guides