Integrated Realtek RTL8161GSH-CH 10/100/1000 NIC:
|
Ethernet Features
|
- 10 Mbit/s operation (10BASE-T; IEEE 802.3i; IEEE 802.3 clauses 13-14)
- 100 Mbit/s operation (100BASE-TX; IEEE 802.3u; IEEE 802.3 clauses 21-30)
- 1000 Mbit/s operation (1000BASE-T; IEEE 802.3ab; IEEE 8023 clauses 40)
- Auto-Negotiation (Automatic Speed Selection)
- Full Duplex Operation at all Speeds, Half Duplex operation at 10 and 100 Mbit/s
- IEEE 802.1p QoS (Quality of Service) Support
- IEEE 802.1q VLAN support
- IEEE 802.3x Flow Control (IEEE 802.3 clauses 31-32; configurable)
- IEEE 802.3az EEE (Energy Efficient Ethernet)
- Jumbo Frame 9K
- Auto MDI/MDIX Crossover cable detection
|
Power
Management
|
- ACPI compliant - multiple power modes
- Situation-sensitive features reduce power consumption
- Advanced link down power saving for reducing link down power consumption
|
Performance Features
|
-
TCP/IP/UDP Checksum Offload (configurable)
-
Protocol Offload (ARP & NS)
-
Large send offload and Giant send offload
-
Receiving Side Scaling
|
Manageability
|
- Wake-on-LAN from standby and hibernation (Magic Packet and Microsoft Wake-Up Frame); Wake-on-LAN from off (Magic Packet only)
- PXE 2.1 Remote Boot
- Statistics Gathering (SNMP MIB II, Ethernet-like MIB, Ethernet MIB (802.3x, clause 30))
- Comprehensive diagnostic and configuration software suite
- Virtual Cable Doctor for Ethernet cable status
|
Interface
|
PCI Express 1.1 to fully support ASPM L0s/L1 and CLKREQ
|
NIC Device Driver Name
|
Realtek PCIe GBE Ethernet Family Controller
|
Realtek 802.11 b/g/n (1x1)*:
|
Wireless LAN Standards
|
- IEEE 802.11b
- IEEE 802.11g
- IEEE 802.11n
|
Interoperability
|
Wi-Fi certified
|
Frequency Band
|
2.402 – 2.482 GHz
|
Data Rates
|
-
802.11b: 1, 2, 5.5, 11 Mbps
-
802.11g: 6, 9, 12, 18, 24, 36, 48, 54 Mbps
-
802.11n: card will support rates for NSS=1 for RX and TX for 20 MHz channels. Short and long guard interval will be supported.
|
Modulation
|
- Direct Sequence Spread Spectrum
- BPSK, QPSK, CCK, 16-QAM, 64-QAM
|
Security1
|
-
IEEE and WiFi compliant 64 / 128 bit WEP encryption for a/b/g mode only AES-CCMP: 128 bit in hardware 802.1x authentication types WPA, WPA2: 802.1x. WPA-PSK, WPA2-PSK, TKIP, and AES.
-
WPA2 certification
-
IEEE 802.11i
-
Cisco Certified Extensions, all versions through V5
-
WAPI
|
Network Architecture
|
Ad-hoc (Peer to Peer)
|
Models
|
Infrastructure (Access Point Required)
|
Roaming
|
IEEE 802.11 compliant roaming between access points
|
Output Power2
|
13.5 dBm, nominal
|
Power Consumption
|
-
Transmit: 2.0 W (max)
-
Receive: 1.6 W (max)
-
Associated to Access Point, Idle: 250 mW nominal
-
Wireless Button Off: 100 mW nominal
-
Radio disabled: 75 mW nominal
|
Power Management
|
- ACPI compliant power management
- 802.11 compliant power saving mode
|
Receiver Sensitivity3
|
-
802.11b:
-
-95 dBm (1 Mbps)
-
-93 dBm (2 Mbps
-
-91 dBm (5.5 Mbps)
-
-88 dBm (11 Mbps)
-
802.11g:
-
-90 dBm (6 Mbps)
-
-89 dBm (9 Mbps)
-
-87 dBm (12 Mbps)
-
-85 dBm (18 Mbps)
-
-82 dBm (24 Mbps)
-
-79 dBm (36 Mbps
-
-76 dBm (48 Mbps)
-
-74 dBm (54 Mbps)
-
802.11n:
|
Antenna Type
|
High efficiency antenna with spatial diversity, mounted in the display enclosure
|
Form Factor
|
PCI-Express Half-MiniCard
|
Weight
|
Less than 10 g
|
Dimensions (Length x
Width x Thickness)
|
4.75 x 26.8 x 30 mm (0.19 x 1.06 x 1.18 in)
|
Voltage, Operating
|
3.3v +/- 9%
|
Temperature
|
|
Humidity
|
|
Altitude
|
|
LED Activity
|
LED Off – Radio OFF; Solid LED On – Radio ON
|
note:
1. Check latest software/driver release for updates on supported security features.
2. Maximum output power may vary by country according to local regulations.
3. Receiver sensitivity is measured at a packet error rate of 8% for 802.11b (CKK modulation) and a packet error rate of 10% for 802.11a/g (OFDM modulation).
*Wireless access point and internet service required. Availability of public wireless access points limited.
|
Intel Dual Band Wireless-AC 3160 802.11 ac (1x1) WiFi and Bluetooth 4.0 Combo* Adaptor
|
Dimensions (H x W x D)
|
Standard: 26.80 mm x 30.00 mm x 2.4 mm Max (Top Side) / 1.35 mm Max (Bottom Side)
Low profile: 22 mm x 30.00 mm x 1.5 mm Max (Top Side) / 0.6 mm Max (Bottom Side)
NGFF: 22 mm x 30 mm, single sided
|
Diversity
|
No diversity support
|
Radio ON/OFF Control
|
Supported in both hardware and software
|
Connector interface
|
Half Mini Card form factor, based on PCIe electrical interface
Next Generation Form Factor, A-SD electrical interface definition support
|
LED Output
|
On/Off
|
Operating Temperature (Adapter Shield)
|
0° to +80° C
|
Humidity Non-Operating
|
50% to 90% RH non-condensing (at temperatures of 25°C to 35°C)
|
Operating Systems
|
Microsoft Windows 7, Microsoft Windows 8, Linux
|
Wi-Fi Alliance
|
Wi-Fi CERTIFIED for 802.11ac, Wi-Fi CERTIFIED a/b/g, Wi-Fi CERTIFIED n, WMM, WPA, WPA2, and WPS, WPS 2.0, Protected Management Frames, Wi-Fi Direct for peer to peer device connections
|
Microsoft WHQL
|
Yes
|
IEEE WLAN Standard
|
-
IEEE 802.11abgn
-
802.11ac
-
802.11d
-
802.11e
-
802.11i
-
802.11h
-
802.11w
|
Architecture
|
Infrastructure and SoftAP; Supports simultaneous Client and SoftAP modes in 2.4 GHz or 5GHz
|
Roaming1
|
ACPI and PCI Express compliant power management
802.11 compliant power saving mode
|
Authentication
|
-
WPA
-
WPA2
-
802.1X
-
EAP-TLS
-
TTLS
-
PEAP
-
LEAP
-
EAP-FAST
-
EAP-SIM
-
EAP-AKA
|
Authentication Protocols
|
-
PAP
-
CHAP
-
TLS
-
GTC
-
MS-CHAP
-
MS-CHAPv2
|
Encryption
|
|
Wi-Fi Direct Encryption and Authentication
|
|
Product Safety
|
UL, C-UL, CB (IEC 60950-1)
|
Management Frame Protection
|
802.11w (WFA- Protected Management Frames)
|
Retail (Credit Card Processing)
|
|
Government
|
|
note:
1. Roaming is supported only within each respective band and mode of access points.
2. Microsoft Windows 7 only.
|
HP Integrated Module with Bluetooth 4.0+EDR Wireless Technology
|
Bluetooth Specification
|
Dual Mode Bluetooth* 2.1, 2.1+EDR, 3.0, 3.0+HS, 4.0 (BLE)
|
Dimensions (H. W. D.)
|
30 x 6.5 x 3.25 mm (1.18 x 0.26 x 0.13 in)
|
Frequency Band
|
2402 to 2480 MHz
|
Number of Available Channels
|
79 (1 MHz) available channels
|
Data Rates and Throughput
|
-
3 Mbps data rate; throughput up to 2.17 Mbps
-
Synchronous Connection Oriented links up to 3, 64 kbps, voice channels
-
Asynchronous Connection Less links 2178.1 kbps/177.1 kbps asymmetric or 1306.9 kbps symmetric
|
Transmit Power
|
-1.5 dBm to 4 dBm (Bluetooth Class II)
|
Receiver Sensitivity
|
Better than -20 dBM at 0.1 % raw bit error rate
|
Power Consumption
|
-
Peak (Tx) 264 mW
-
Peak (Rx) 231 mW
-
Sleep <1 mW
|
Antenna
|
Internally integrated within module
|
Range
|
Up 33 ft (10 m)
|
Electrical Interface
|
|
Bluetooth Software Supported
|
- Broadcom Bluetooth for Windows
- Microsoft Windows Bluetooth Software
|
Link Topology
|
Point to Point, Multipoint Pico Nets up to 7 slaves
|
Security
|
Full support of Bluetooth Security Provisions
|
Power Management
|
-
Microsoft Windows ACPI, and USB Bus Support
-
Self configurable to optimize power conservation in all operating modes, including Standby, Hold, Park, and Sniff
|
Certifications
|
All necessary regulatory approvals for supported countries, including:
|
Temperature
|
|
Humidity
|
-
Operating
0% to 90%
-
Non-operating
0% to 95%
|
Altitude
|
-
Operating
4,572 m (15,000 ft)
-
Non-operating
12,192 m (40,000 ft)
|
Bluetooth Profiles Supported
|
-
Serial Port Profile (SPP)1
-
Service Discovery Application Profile (SDAP)
-
Dial-Up Networking (DUN)1,2
-
Generic Object Exchange Profile (GOEP)1,2
-
Object Push Profile (OPP)1,2
-
File Transfer Profile (FTP)
-
Synchronization Profile (SYNC)
-
Hard Copy Cable Replacement (HCRP)1,2
-
Personal Area Networking Profile (PAN)1,2
-
Human Interface Device Profile (HID)1,2
-
FAX Profile (FAX)
-
Basic Imaging Profile (BIP)2
-
Headset Profile (HSP)
-
Hands Free Profile (HFP)
-
Advanced Audio Distribution Profile (A2DP)
note:
1. indicates the profile is supported by Microsoft Windows XP SP2
2. indicates the profile is part of Windows Vista
* Wireless access point and internet service required. Availability of public wireless access points limited. The specifications for the 802.11ac WLAN are draft specifications and are not final. If the final specifications differ from the draft specifications, it may affect the ability of the notebook to communicate with other 802.11ac WLAN devices.
|