HP LaserJet M607, M608, M609, M610, M611, M612, M612, E60055, E60065, E60075, E60155, E60165, E60175; MFP M631, M632, M633, M634, M635, M636, M637, E62555, E62565, E62575, E62655, E62665, E62675 - Removal and replacement: Secondary transfer roller

Follow these steps to remove the secondary transfer roller:.

1. Do the following:

   • : Open the rear door.

   • : Open the right door.

   Open the rear door or the right door

   

2. Locate the secondary transfer roller within the transfer assembly.

   Locate the secondary transfer roller

   

3. Do the following:

   • At each end of the secondary transfer roller, release two tabs.

   • Lift up and remove the secondary transfer roller assembly in the direction indicated by the arrows.

   Release four tabs and remove the secondary transfer roller

   

Follow these steps to unpack the replacement assembly.

1. Dispose of the defective part.

   Note:

   HP recommends responsible disposal of the defective part.

   http://www8.hp.com/us/en/hp-information/environment/product-recycling.html

2. Unpack the replacement part from the packaging.

   CAUTION:

   Some parts are sensitive to electrostatic discharge (ESD). Always perform service work at an ESD-protected workstation or mat. If an ESD workstation or mat is not available, touch the sheet-metal chassis to provide a static ground before touching an ESD-sensitive assembly. Protect the ESD-sensitive assemblies by placing them in ESD pouches when they are out of the printer.

   Important:

   Make sure that all of the shipping materials (for example shipping tape) are removed from the replacement part prior to installation.

   Note:

   If the replacement part is a roller or pad, avoid touching the spongy part of it. Skin oils on the roller or pad can cause paper pickup and/or print-quality problems. HP recommends using disposable gloves when handling rollers or pads or washing your hands before touching rollers or pads.

3. To install an assembly, reverse the removal steps.

   Note:

   When applicable, special installation instructions are provided for an assembly at the end of the removal procedure. Always completely read the removal instructions and follow all special installation instructions.

Follow these steps to install the secondary transfer roller:.

1. At each end of the secondary transfer roller, pinch two tabs together to install it.

   Pinch together the four tabs and install the secondary transfer roller

   

2. To correctly seat the secondary transfer roller, make sure that the pin on each end is aligned in the grooves of the transfer assembly.

   Align the end pins of the secondary transfer roller in the grooves

   

3. Press down on each end of the secondary transfer roller and make sure it snaps into place.

   Press down and snap the ends into place

   

4. On the transfer assembly, lift up the left end tab.

   Lift up the transfer assembly left end tab

   

5. Do the following:

   • : Close the rear door.

   • : Close the right door.

   Close the rear door or close the right door