Learn how to install the internal USB ports.
Mean time to repair: 5 minutes
Service level: Basic
When applicable, special installation instructions are provided for an assembly at the end of the removal procedure. Always completely read the removal instructions and follow all special installation instructions.
Disconnect the power cable.
To avoid damage to the printer, turn the printer off, wait 30 seconds, and then remove the power cable before attempting to service the printer.
Use the table below to identify the correct part number for your printer. To order the part, go to www.hp.com/buy/parts
Part number |
Part description |
---|---|
B5L28-67902 |
Two internal USB ports |
No special tools are needed to remove or install this assembly.
Turn the printer power on
Connect the power cable.
Use the power switch to turn the power on.
Make sure that the printer initializes to a Ready state.
Print a configuration page to make sure that the printer is functioning correctly.
Follow these steps to remove the formatter cover.
Follow these steps to remove the accessory from its package.
Save all packaging for recycling.
For complete information about HP recycling programs, go to http://www8.hp.com/us/en/hp-information/environment/product-recycling.html.
Follow these steps to install the internal USB ports.
ESD sensitive part.
The M682 is shown in the figures below. The procedure is also correct for the M681 and M652/M653 models.
Follow these steps to install the formatter cover.