solution Contentsolution Content

HP Color LaserJet Enterprise 5700, 6700, 6701, X557, X55745, X654, X65455, X65465, MFP 5800, 6800, 6801, X57945, X58045, X677, X67755, X67765 - Load paper to Tray 1 (multipurpose tray)

The following information describes how to load paper in Tray 1.

CAUTION:

To avoid jams, never add or remove paper from Tray 1 during printing.

Load Tray 1 (multipurpose tray)

This tray holds up to 100 sheets of 75 grams per square meter20 lb paper, or 10 envelopes.

Note:

Select the correct paper type in the print driver before printing.

Open Tray 1.
Pull out the tray extension to support the paper, if necessary.
Use the adjustment latch to spread the paper guides outward.
Load paper in the tray.

Make sure that the paper fits under the fill line on the paper guides.

Note:
The maximum stack height is 10 mm0.4 in, or approximately 100 sheets of 75 grams per square meter 20 lb paper.
Using the adjustment latch, adjust the side guides so that they lightly touch the paper stack, but do not bend it.

Position paper correctly in Tray 1 (multipurpose tray) to ensure the best print quality.

Letterhead or preprinted paper - Portrait
Duplex mode	How to load paper
1-sided printing	Face-down Bottom edge leading into the printer Right side of pre-printed image leading into the printer
Automatic 2-sided printing or with Alternative Letterhead Mode enabled	Face-up Top edge leading into the printer Left side of pre-printed image leading into the printer

Letterhead or preprinted paper - Landscape
Duplex mode	How to load paper
1-sided printing	Face-down Right edge of pre-printed image leading into the printer Bottom edge leading into the printer
Automatic 2-sided printing or with Alternative Letterhead Mode enabled	Face-up Left side of the pre-printed image leading into the printer Top edge leading into the printer

Prepunched paper - Portrait
Duplex mode	How to load paper
1-sided printing	Face-down Holes toward the back of the printer
Automatic 2-sided printing or with Alternative Letterhead Mode enabled	Face-up Holes toward the back of the printer

Prepunched paper - Landscape
Duplex mode	How to load paper
1-sided printing	Face-down Holes away from the printer
Automatic 2-sided printing or with Alternative Letterhead Mode enabled	Face-up Holes towards the printer

What can we help you with?