HP LaserJet Enterprise M712 and HP LaserJet Enterprise MFP M725 - Replace the Document Feeder Pickup and Feed Roller Assembly

note:

To see a short video demonstrating this procedure, click here.

• Use the table below to identify the correct kit part number for your product, and then go to www.hp.com/buy/parts to order the kit.

  Kit part number	Description
  L2725-60002	Document-feeder-roller maintenance kit

• No special tools are required to install this kit.

1. Do the following:
   1. Turn off the product.
   2. Disconnect the power cable.

        warning:

      To avoid damage to the product, turn the product off, wait five seconds, and then remove the power cord before attempting to service the product.

2. Open the document feeder cover and locate the document feeder pickup and feed roller assembly.
   
3. Release one tab (callout 1) to open the assembly cover.
   
4. Push the roller assembly toward the front of the product, and then pull the assembly away from the document feeder.
   

note:

HP recommends responsible disposal of the duplex reverse guide.

1. Position the roller assembly in the document feeder.
   
2. Attach one tab (callout 1) to close the assembly cover.
   
3. Close the document feeder cover.
   
4. Do the following:
   1. Connect the power cable.
   2. Turn on the product.