HP Color LaserJet Enterprise MFP M577, HP Color LaserJet Managed MFP E57540 - Removal and replacement: Hardware Integration Pocket (HIP) cover

Introduction

This document provides the procedures to remove and replace the M577 HIP cover.

Use the table below to identify the correct part number for your printer. To order the part, go to www.hp.com/buy/parts.

HIP cover (M577) part number
B5L46-40021	HIP cover (M577)

No special tools are required to install this part.

Make sure that the HIP cover is fully seated after replacing it.

Step 1: Remove the HIP cover

Locate the HIP cover.

Figure : Locate the HIP cover
Use a small flat-blade screwdriver to release the tabs on the HIP cover.

Figure : Release the HIP cover tabs
Rotate the cover up and off of the printer to remove it.

Figure : Remove the cover

Unpack the replacement assembly from the packaging.

For complete information on HP's recycling programs, go to Product return and recycling.

note:
HP recommends responsible disposal of the defective assembly.

Recycle and unpack

Figure : Recycle and unpack

Position the tabs (callout 1) on the HIP cover in the slots (callout 2) in the printer.

Figure : Position the tabs
Rotate the cover down.

note:
Make sure that the tabs on the cover snap into place.

Figure : Rotate the cover down
Make sure that the HIP cover is fully seated after installing it.

Figure : Check the installation