HP LaserJet Enterprise MFP M630 - Replace the output bin and bin base assembly

• Use the table below to identify the correct kit part number for your product, and then go to www.hp.com/buy/parts to order the kit.

  Output bin and bin base assembly part number
  B3G84-69702	Output bin assembly kit with instruction guide

• No special tools are required to install this kit.

1. Slide the bin base away from the product (callout 1) until it stops, slightly lift up on the assembly to disengage the slide rails (callout 2), and then remove the assembly (callout 3).
   Figure : Remove the output bin
   

note:

HP recommends responsible disposal of the defective assembly.

1. Position the assembly at an angle to the product (callout 1), lower the assembly into place (callout 2) while engaging the slide rails (callout 3), and then slide the bin base into the product.
   Figure : Install the output bin