This document provides the procedures to remove and replace the secondary transfer roller and the intermediate transfer belt (ITB).
Before performing service
Turn the printer power off
-
Disconnect the power cable.
warning:
To avoid damage to the printer, turn the printer off, wait 30 seconds, and then remove the power cord before attempting to service the printer.
Use the table below to identify the correct part number for your printer. To order the part, go to www.hp.com/buy/parts.
Secondary transfer roller kit part number
|
|
B5L24-67901
|
Secondary transfer roller and intermediate transfer belt (ITB) with instruction guide
|
Required tools
No special tools are required to install this part.
After performing service
Make sure that the right door is fully closed after replacing the secondary transfer roller and ITB.
Turn the printer power on
-
Connect the power cable.
-
Use the power switch to turn the power on.
Post service test
Print a configuration page to make sure that the printer is functioning correctly.