This document provides the procedures to remove and replace the fuser.
Mean time to repair: 5 minutes
Service level: Basic
Turn the printer power off
Disconnect the power cable.
To avoid damage to the printer, turn the printer off, wait 30 seconds, and then remove the power cord before attempting to service the printer.
Use the table below to identify the correct part number for your printer. To order the part, go to www.hp.com/buy/parts.
Part number |
Part description |
---|---|
B5L35-67902 |
Fuser (110V) with instruction guide |
B5L36-67902 |
Fuser (220V) with instruction guide |
No special tools are required to install this part.
Make sure that the right door is fully closed after replacing the fuser.
Turn the printer power on
Connect the power cable.
Use the power switch to turn the power on.
Print a configuration page to make sure that the printer is functioning correctly.
Follow these steps to remove the fuser.
Follow these steps to unpack the replacement assembly.
Follow these steps to install the fuser.
Follow these steps to reset the supplies counter.
The procedures in this section are for printers with FutureSmart 3 (FS3) firmware installed only)