hp-support-head-portlet

- ${title}
hp-contact-secondary-navigation-portlet

- ${title}
hp-share-print-widget-portlet

- ${title}
hp-concentra-wrapper-portlet

- ${title}
HP LaserJet Enterprise 500 Color MFP M575/Flow MFP 575 - Removal and replacement: Formatter PCA
This document provides the procedures to remove and replace the formatter.
When applicable, special installation instructions are provided for an assembly at the end of the removal procedure. Always completely read the removal instructions and follow all special installation instructions.
Mean time to repair:10 minutes
Service level:Intermediate
Before performing service
Turn the printer power off
-
Disconnect the power cable.
Warning:To avoid damage to the printer, turn the printer off, wait 30 seconds, and then remove the power cord before attempting to service the printer.
-
Disconnect all network cables.
CAUTION:This part contains components that are electrostatic discharge (ESD) sensitive. To reduce the possibility of ESD damage, always touch the sheet-metal chassis to ground yourself before touching an ESD-sensitive part.
Important:Do not replace the formatter, DC controller, and eMMC PCA or hard-disk drive simultaneously during a single printer servicing. Doing so might cause the printer to become unstable or inoperable.
Use the table below to identify the correct part number for your printer. To order the part, go to www.hp.com/buy/parts.
Formatter part number |
|
---|---|
CD644-67909 |
Formatter assembly kit |
CD644-67910 |
Formatter assembly kit (China) |
Required tools
-
No special tools are required to install this kit.
After performing service
Turn the printer power on
-
Connect the power cable.
-
Use the power switch to turn the power on.
Post service test
Make sure that the printer initializes to a Ready state.
Print a configuration page to make sure that the printer is functioning correctly.
Remove the formatter PCA
Follow these steps to remove the formatter PCA.
ESD sensitive component.
Remove the fax PCA and cable
Follow these steps to remove the fax PCA and cable.
ESD sensitive component.
Remove the hard disk drive (HDD)
Follow these steps to remove the hard disk drive (HDD).
ESD sensitive component.
The product has a hard disk drive (HDD) installed. If you install a replacement disk drive, you must reload the product firmware.
Unpack the replacement assembly
Follow these steps to unpack the replacement assembly.
hp-feedback-input-portlet

- ${title}
hp-feedback-banner-portlet

- ${title}
hp-country-locator-portlet

- ${title}

hp-detect-load-my-device-portlet

- ${title}
hp-hero-support-search

- ${title}