HP PageWide Enterprise, HP PageWide Managed - Removal and replacement: Printhead wiper kit

Follow these steps to remove the printhead wiper.

1. From the printer control panel, do the following:

   • Scroll to, and then select the Settings button.

   • Open the following menus:

     • Manage Supplies

   • Select the Replace Printhead Wiper item, and then select the Replace button.

     Note:

     Follow the control-panel prompts (with the associated steps below).

   • When prompted, select the Finish button to complete the installation.

2. Open the right door.

   Open the right door

   

3. Open the cartridge door.

   Open the cartridge door

   

4. Wait for the printhead wiper to eject, and then locate the printhead wiper (callout 1).

   Locate the printhead wiper

   

5. Grasp the printhead wiper, and then pull it straight out of the printer.

   Remove the printhead wiper

   

Follow these steps to unpack the replacement assembly.

1. Dispose of the defective part.

   Note:

   HP recommends responsible disposal of the defective part.

   http://www8.hp.com/us/en/hp-information/environment/product-recycling.html

2. Unpack the replacement part from the packaging.

   CAUTION:

   Some parts are sensitive to electrostatic discharge (ESD). Always perform service work at an ESD-protected workstation or mat. If an ESD workstation or mat is not available, touch the sheet-metal chassis to provide a static ground before touching an ESD-sensitive assembly. Protect the ESD-sensitive assemblies by placing them in ESD pouches when they are out of the printer.

   Important:

   Make sure that all of the shipping materials (for example shipping tape) are removed from the replacement part prior to installation.

   Note:

   If the replacement part is a roller or pad, avoid touching the spongy part of it. Skin oils on the roller or pad can cause paper pickup and/or print-quality problems. HP recommends using disposable gloves when handling rollers or pads or washing your hands before touching rollers or pads.

3. To install an assembly, reverse the removal steps.

   Note:

   When applicable, special installation instructions are provided for an assembly at the end of the removal procedure. Always completely read the removal instructions and follow all special installation instructions.

Follow these steps to install the printhead wiper.

1. Position the printhead wiper in the printer, and then push it straight in to install it.

   Continue to push the printhead wiper into the printer until it begins to move on its own, and then follow the control panel prompts.

   Note:

   Prompts appear on the control-panel display to remove and then reinstall the printhead wiper if it is not correctly installed.

   Install the printhead wiper

   

2. Close the cartridge door.

   Close the cartridge door

   

3. Close the right door, and then wait for the printer to verify the replacement printhead wiper installation.

   Close the right door