Error:

Javascript is disabled in this browser. This page requires Javascript. Modify your browser's settings to allow Javascript to execute. See your browser's documentation for specific instructions.

hp-support-head-portlet

Actions

HP Customer Support - Knowledge Base

hp-contact-secondary-navigation-portlet

Actions

hp-share-print-widget-portlet

Actions

hp-concentra-wrapper-portlet

Actions

HP ProBook 4710s Notebook PC - Removing and Replacing the Optical Drive

Summary of instructions

Parts return

Introduction

This document is provided to assist in removing and replacing the Optical Drive for the HP ProBook 4710s Notebook PC.

Minimum skill level

The End User requires no hardware-specific training to replace the defective part. The End user should have familiarity with system hardware and software requiring repair.

Tools required

Torx 8 (T8) screwdriver
Small, flat-bladed screwdriver or a flat-bladed alignment tool

Parts required

note:
Part numbers are subject to change.

The replacement part number will vary depending on the Optical Drive that is being replaced. If a part is listed as 'Yes' under 'Requires Return' then the defective part needs to be returned to HP. Click here for more information on returning parts to HP.

Description	Part Number	Requires Return
Blu-ray Disc (BD) SuperMulti optical drive with DVD R/RW Double-Layer - SATA interface	535759-001	Yes
DVD-ROM drive - 12.7mm form factor	535760-001	Yes
DVD+/-RW and CD-RW Super Multi Double-Layer combo drive with LightScribe - 12.7mm form factor	535761-001	Yes

note:
For customers in countries/regions with RoHS legislation* (e.g. EU, China, etc.) restricting the use of hazardous substances in electrical equipment. The use of the Original Spare part is regulated by RoHS legislation. If your unit contains a part that is labeled with the Modified Spare number, the Modified Spare must be ordered as the replacement part. If your unit contains a part that is labeled with the Original Spare number, please order the Original Spare as the replacement part. In this case either the Original Spare or the Modified Spare may be shipped which will not affect performance or functionality of the unit.

Summary of instructions

To view a video demonstrating the procedure for removing the Optical Drive, click on the link below. Or use the product video listing on the HP Services Media Library, then select Optical Drive from the menu on the upper left hand side of the screen.

Click here to view the Optical Drive removal video (right-click on the link to open in a new window/tab).

Optical Drive removal

Review the safety considerations before performing the steps listed below by clicking on the following link:

Click here to view the precautions.

caution:
Failure to comply with the precautions could result in damage to your product or loss of data.
Remove the battery, switch cover and keyboard.

Click Here for instructions to remove the Battery, Switch Cover and Keyboard.
Remove the bronze 6mm T8 Torx-head locking screw that secures the optical drive to the base enclosure.
Using a flat bladed tool, push the tab on the rear of the optical drive to partially remove it.
Remove the optical drive from the base enclosure.

Optical Drive replacement

Insert the optical drive into the optical drive bay until the tray door bezel is flush with the side of the base enclosure.
Replace the bronze 6mm T8 Torx-head screw that secures the optical drive to the base enclosure.