hp-support-head-portlet

Actions
Loading...
HP Customer Support - Knowledge Base

hp-contact-secondary-navigation-portlet

Actions
Loading...

hp-share-print-widget-portlet

Actions
Loading...
  • Information
    Learn how to upgrade to Windows 11

    Windows 11 Upgrade Guide

  • Feedback

hp-concentra-wrapper-portlet

Actions
Loading...

HP Z600 Workstation - Removing and Replacing the Right side panel

This document pertains only to HP Z600 Workstations with the following case design:

Before you begin

  • You need a Torx-15 screwdriver.
  • Turn off the workstation, and then disconnect all cables. Disconnect the Ethernet or modem cable before disconnecting the power cord.
  • Move the workstation to a clear, flat, stable work surface over a non-carpeted floor.
  • HP strongly recommends the use of an anti-static wrist strap and a conductive foam pad when working on the workstation.
  • Do not remove a component from its protective packaging until you are ready to install it.
  warning:
The edges of metal panels can cut skin. Be careful not to slide skin along any interior metal edge of the workstation.
  caution:
This product contains components that can be damaged by electrostatic discharge (ESD). To reduce the chance of ESD damage, work over a noncarpeted floor, use a static dissipative work surface (such as a conductive foam pad), and wear an ESD wrist strap connected to a grounded surface.

Video overview (in English)

To view a video demonstrating the procedure for removing the right side panel, right-click Right side panel removal video and select Open link in new window/tab.

Replacement part information

The following HP part numbers are known to be compatible with this system:
note:
Part numbers are subject to change.
Description
Part Number
Requires Return
Right side panel
534475-001 (Modified)
No
* If a part is listed as "Yes" under "Requires Return" then the defective part needs to be returned to HP. For more information about returning parts to HP select one of the links below:
note:
For customers in countries/regions with RoHS legislation* (e.g. EU, China, etc.) restricting the use of hazardous substances in electrical equipment. The use of the Original Spare part is regulated by RoHS legislation. If your unit contains a part that is labelled with the Modified Spare number, the Modified Spare must be ordered as the replacement part. If your unit contains a part that is labelled with the Original Spare number, please order the Original Spare as the replacement part. In this case either the Original Spare or the Modified Spare may be shipped which will not affect performance or functionality of the unit.

Right side panel removal

Step 1
With all cables disconnected from the workstation, remove the access panel.
For more information about removing the access panel, refer to the HP support document Instructions on how to remove the access panel.
Step 2
Remove the four Torx-15 screws that secure the right side panel to the bottom of the chassis.
Step 3
Slide the right side panel back about half an inch (1.3 cm) and then lift and remove the panel.

Right side panel replacement

Step 1
Position the right side panel over the chassis so that the aligning pins engage with the keyholes in the chassis rail.
Step 2
Press down on the right side panel and slide it forward until it locks in place.
Step 3
Replace the two Torx-15 screws that secure the right side panel to the bottom of the chassis.
Step 4
Replace the access panel.

hp-feedback-input-portlet

Actions
Loading...

hp-feedback-banner-portlet

Actions
Loading...

hp-country-locator-portlet

Actions
Loading...
Country/Region: Flag United States

hp-detect-load-my-device-portlet

Actions
Loading...