hp-support-head-portlet

Actions
Loading...
HP Customer Support - Knowledge Base

hp-contact-secondary-navigation-portlet

Actions
Loading...

hp-share-print-widget-portlet

Actions
Loading...
  • Information
    We are upgrading our website

    If you experience errors during this time, please try again later. 

hp-concentra-wrapper-portlet

Actions
Loading...

Evo Notebook N1020v - Installing an Heat Spreader

Installing Heat Spreader

Removing the Heat Spreader

  1. Prepare the computer for disassembly.
  2. Remove the LED cover.
  3. Remove the keyboard.
  4. Disconnect the fan cable 1 from the system board.
  5. Remove the following screws:
    • One TM2.5 x 5.0 screw 2 next to the fan
    • One TM2.5 x 5.0 screw 3 that secures the display video cable ground loop
    • Four spring-loaded TM2.5 x 14.0 shoulder screws 4
    • One TM2.5 x 8.0 screw 5 next to the keyboard and TouchPad ZIF connectors

    NOTE: Removal Sequence
    The four spring-loaded shoulder screws should be removed and installed in the 1, 2, 3, 4 sequence stamped on the heat spreader adjacent to each screw hole.
  6. Remove the display video cable 1 from the routing channel in the heat spreader.
  7. Lift the right side of the heat spreader until it rests at an angle 2.
  8. Slide the heat spreader to the right at an angle 3 and remove the heat spreader from the base enclosure.

Installing the Heat Spreader

Reverse the preceding procedures to install a Heat Spreader.

hp-feedback-input-portlet

Actions
Loading...

hp-feedback-banner-portlet

Actions
Loading...

hp-country-locator-portlet

Actions
Loading...
Country/Region: Flag United States

hp-detect-load-my-device-portlet

Actions
Loading...