The Color Calibration can only be done from the Proofing Engine Manager.
Figure : Printhead Alignment page
Color Calibration should be performed during the following instances:
-
It is recommended at least once a week.
-
When a different media type is selected or changed.
-
The environmental conditions have changed from the environmental condition when the Color Calibration was applied.
-
Printhead(s) have been replaced.
-
The drop volume of any of the printheads has changed dramatically.
If the Color Calibration fails, print the Information page (press Power and then press Continue four (4) times) and check the list of warnings under the printer status section.
