hp-support-head-portlet

Actions
Loading...

Welcome to HP Customer Support

hp-contact-secondary-navigation-portlet

Actions
Loading...

hp-share-print-widget-portlet

Actions
Loading...
  • Information
    We are upgrading our website

    If you experience errors during this time, please try again later. 

hp-concentra-wrapper-portlet

Actions
Loading...

HP CD-ROM Server for Ethernet Networks - Installing the Tower Module in a CD-ROM Tower

INSTALLING THE TOWER MODULE IN A CD-ROM TOWER
The HP CD-ROM Server Tower Module is intended to be installed in standard CD-ROM towers. The dimension of the CD-ROM server is the same as for standard CD-ROM drives, which is 5.25 inches half-height.
To install the CD-ROM server, follow the steps below:
  warning:
To avoid the risk of electrical shock or other injury, disconnect power from the tower before removing the cover, chassis, or enclosure.
  1. Prepare the CD-ROM tower for the installation. For example, remove the chassis cover.
  2. Record the LAN hardware (MAC) address of the CD-ROM server. You will need this number during the network configuration. The address is found on the label on the bottom of the server.
      note:
    An additional label that identifies the same LAN hardware address is included with the HP CD-ROM Server Tower Module. This label is intended to be attached to the outside of the tower chassis (the CD-ROM server might not be accessible after it is installed).
  3. Slide the CD-ROM server into the tower.
  4. If required, use the four screws supplied to fix the CD-ROM server in place. Use the upper or lower holes depending on the type of tower and its mounting requirements.
      caution:
    The length of the screws must not exceed 5 mm (0.2 inch). If they do, the internal components of the CD-ROM server may be damaged.
  5. Attach the power cable to the CD-ROM server. The power connector on the CD-ROM server is a standard PC 4-pin power connector (12 and 5 Vdc).
  6. Connect the external network connector board to the CD-ROM server using the ribbon cable. The network connector board includes network connectors and the Reset button.
The board is intended to be mounted on the back of the CD-ROM tower. The mounting plate on the board fits into standard parallel-connector cut-out holes available on most towers.

hp-feedback-input-portlet

Actions
Loading...

hp-online-communities-portlet

Actions
Loading...

Ask the community!


Support Forum

Support Forum

Join the conversation! Find Solutions, ask questions, and share advice with other HP product owners. Visit now


hp-feedback-banner-portlet

Actions
Loading...

hp-country-locator-portlet

Actions
Loading...
Country: Flag United States

hp-detect-load-my-device-portlet

Actions
Loading...