Error:

У цьому браузері вимкнено Javascript. Цій сторінці потрібен Javascript. Увімкніть Javascript в налаштуваннях браузера. Інструкції наведено в документації браузера.

hp-support-head-portlet

Дії

Завантаження...

Підтримка користувачів НР - База знань

hp-contact-secondary-navigation-portlet

Дії

Завантаження...

hp-share-print-widget-portlet

Дії

Завантаження...

Інформація

Дізнайтесь, як перейти на Windows 11
Посібник з оновлення Windows 11

Відгук

hp-concentra-wrapper-portlet

Дії

Завантаження...

Loading Paper and Envelopes for the HP Deskjet 3050A (J611) and 3050 (J610) All-in-One Printer Series

Introduction

This document provides instructions for loading plain paper, photo paper, and envelopes.

Loading plain paper

Use the following steps to load paper in the product.

Raise the input tray.

Figure : Raise the input tray
Lower the output tray, and then pull out the tray extender.

Figure : Pull out the tray extender
Slide the paper width guide to its outermost position.

Figure : Slide the paper width guide to its outermost position
Load a stack of plain paper into the input tray, print-side up. Slide the stack of paper in until it stops.

Figure : Load paper
Slide the paper width guide snugly against the paper.

Figure : Slide the paper width guide snugly against the paper

Loading photo paper

Use the following steps to load photo paper in the product.

Raise the input tray.

Figure : Raise the input tray
Lower the output tray, and then pull out the tray extender.

Figure : Pull out the tray extender
Slide the paper width guide to the left.

Figure : Slide the paper width guide to the left
Load a stack of photo paper into the input tray with the short edge down and print-side up. Slide the stack of paper in until it stops.

note:
If the photo paper you are using has perforated tabs, load the paper so that the tabs are on top.
Slide the paper width guide inward until it stops at the edge of the paper.

Figure : Slide the paper width guide inward

note:
Do not leave any photo paper in the input tray after you finish printing, as the quality of the paper might deteriorate. Store photo paper in a sealed bag in a cool, dark place.

Loading envelopes

Use the following steps to load envelopes in the product.

note:
You can load one or more envelopes in the tray, but do not load more than five envelopes at a time. Do not use shiny or embossed envelopes or envelopes that have clasps or windows.

Raise the input tray.

Figure : Raise the input tray
Lower the output tray, and then pull out the tray extender.

Figure : Pull out the tray extender
Slide the paper width guide to the left.

Figure : Slide the paper width guide to the left
Load one or more envelopes into the far-right side of the input tray with the print-side up and with the flap on the left-side, and then slide the paper width guide inward until it stops at the edge of the envelopes.

Figure : Load envelopes