HP OfficeJet 8010, Pro 8020 and 8030 Printers - First Time Printer Setup

Примечание.

If you are looking for the printer software, go to 123.hp.com.

1. Remove the printer from the box.
2. Remove the film from the printer control panel.
   
3. Lift the scanner lid, and then remove the packing material from the scanner glass.
   
4. Close the scanner lid.
   

Примечание.

Do not connect a USB cable at this time. The connection to the computer is established during software installation.

1. Connect the power cord to the rear of the printer, and then plug the other end of the power cord into an electrical outlet.
   
2. If the printer does not turn on automatically, press the Power button.
3. On the printer control panel, touch your preferred language, and then touch Confirm.
4. Touch your country/region, and then touch Confirm.

1. Open the front door, and then lift the ink cartridge access door.
   
2. Wait until the carriage stops moving before you continue.
3. Remove the protective plastic from the carriage.
   
4. Remove an ink cartridge from its package, and then pull the orange pull-tab straight back to remove the plastic wrap.

     Внимание!

   Make sure you remove the orange pull-tab and plastic wrap completely before you remove the orange cap in the next step. Otherwise, ink might leak from the ink cartridge. When you remove the plastic wrap, the paper label on the top of the ink cartridge tears slightly, which is necessary to properly vent the ink cartridge.

   
5. Hold the ink cartridge by its sides, and then twist the orange cap counter-clockwise to remove it from the ink cartridge.
   
6. Slide the ink cartridge into its slot, and then press down on the ink cartridge until it snaps into place.
   
7. Repeat these steps to install the other ink cartridges.
8. Close the front door and ink cartridge access door.
9. When the printer finishes initializing, touch OK.

1. Slide out the input tray, remove any packing material, and then slide out the paper guides.
   
2. Load plain white paper into the input tray with the short edge forward and the print side down.
   
3. Slide in the paper width guides in until they rest against the edges of the paper.
   
4. Insert the input tray into the printer.
5. On the printer control panel, touch OK.
   An alignment page prints.
6. Open the scanner lid, and then place the alignment page on the scanner glass. Place the page face down with the top of the page aligned to the engraved guides near the back corner of the glass.
   
7. Close the scanner lid, and then touch Scan.
   The printer scans the alignment page, and an Alignment Successful message displays on the control panel.
8. Recycle the alignment page and packing materials.