hp-support-head-portlet

Actions
Loading...

Welcome to HP Customer Support

hp-contact-secondary-navigation-portlet

Actions
Loading...

hp-share-print-widget-portlet

Actions
Loading...
  • Information
    Welcome Samsung Printer Customers

    Need support for your Samsung Printer?  HP is here to help!  Learn More

hp-concentra-wrapper-portlet

Actions
Loading...

Removing and Replacing the Service Door for HP Mini Notebook PCs

This document pertains to HP Mini 1104, 110-4100/4300, 200-4200, 210-4000/4100, and CQ10-1100 series notebook computers.
HP Mini notebook computer
Before you begin
  • Turn off the computer. Disconnect the Ethernet or modem cable. Disconnect the power cord.
  • Transfer the computer to a clear, flat, stable work surface over a non-carpeted floor.
  • HP strongly recommends the use of an anti-static wrist strap and a conductive foam pad when working on the computer.
  • Do not remove a component from its protective packaging until you are ready to install it.
  warning:
The edges of metal panels can cut skin. Be careful not to slide skin along any interior metal edge of the computer.
  warning:
Before starting, power off the computer and wait for components to cool before starting these procedures.
  caution:
This product contains components that can be damaged by electrostatic discharge (ESD). To reduce the chance of ESD damage, work over a noncarpeted floor, use a static dissipative work surface (such as a conductive foam pad), and wear an ESD wrist strap connected to a grounded surface.
Video overview
View the following video before using the steps in this article.
  note:
For best quality on dial-up connections, wait until the video has fully loaded before viewing.
  note:
The video and graphics in this article depict a specific configuration of notebook computer. These same removal and replacement procedures apply to all configurations for all HP Mini 1104, 110-4xxx, 200-4xxx, and Compaq Mini CQ10-1xxx series notebook computers.
Removing the service door
  warning:
Make sure the computer is disconnected from power before starting.
Follow the steps in this section to remove the service door.
Step 1
Remove the battery.
For more information about removing the battery, refer to the HP support document Removing and Replacing the Battery.
Removing the battery
Step 2
On the bottom of the notebook, slide the battery release latch into the release position to partially eject the service door.
The release latch is identified by a battery icon.
Sliding the battery release latch
Step 3
Slide the service door toward the front of the computer.
Sliding the service door
Step 4
Lift and remove the service door.
Removing the service door
Replacing the service door
Use the steps in this section to replace the service door.
Step 1
Align the service door in place.
Aligning the service door
Step 2
Slide the service door towards the front of the computer until it is properly seated and the battery release latch clicks.
Sliding the service door in
Step 3
Replace the battery.
For more information about replacing the battery, refer to the HP support document Removing and Replacing the Battery.
Pressing down on the battery

hp-feedback-input-portlet

Actions
Loading...

hp-online-communities-portlet

Actions
Loading...

Ask the community!


Support Forum

Support Forum

Join the conversation! Find Solutions, ask questions, and share advice with other HP product owners. Visit now


hp-feedback-banner-portlet

Actions
Loading...

hp-country-locator-portlet

Actions
Loading...
Country: Flag Thailand

hp-detect-load-my-device-portlet

Actions
Loading...