HP Color LaserJet Enterprise M751, M856, Managed E75245, E85055 - Removal and replacement: embedded Multi-Media Card (eMMC) (M751/E75245/M856/E85055)

Follow these steps to remove the formatter cover.

1. Loosen one thumbscrew (callout 1), and then slide the formatter cover (callout 2) away from the printer to remove it.

   Remove the formatter cover

   

Follow these steps to remove the embedded Multi-Media Card (eMMC) (M751/E75245/M856/E85055).

1. Locate the embedded Multi-Media Card (eMMC) on the formatter board.

   Locate the eMMC

   

2. Lift the eMMC off of the formatter board to remove it.

   Remove the eMMC

   

Follow these steps to unpack the replacement assembly.

1. Dispose of the defective part.

   Note:

   HP recommends responsible disposal of the defective part.

   http://www8.hp.com/us/en/hp-information/environment/product-recycling.html

2. Unpack the replacement part from the packaging.

   CAUTION:

   Some parts are sensitive to electrostatic discharge (ESD). Always perform service work at an ESD-protected workstation or mat. If an ESD workstation or mat is not available, touch the sheet-metal chassis to provide a static ground before touching an ESD-sensitive assembly. Protect the ESD-sensitive assemblies by placing them in ESD pouches when they are out of the printer.

   Important:

   Make sure that all of the shipping materials (for example shipping tape) are removed from the replacement part prior to installation.

   Note:

   If the replacement part is a roller or pad, avoid touching the spongy part of it. Skin oils on the roller or pad can cause paper pickup and/or print-quality problems. HP recommends using disposable gloves when handling rollers or pads or washing your hands before touching rollers or pads.

3. To install an assembly, reverse the removal steps.

   Note:

   When applicable, special installation instructions are provided for an assembly at the end of the removal procedure. Always completely read the removal instructions and follow all special installation instructions.

Follow these steps to install the embedded Multi-Media Card (eMMC) (M751/E75245/M856/E85055).

1. Position the connector (callout 1) on the eMMC card into the connector (callout 2) on the formatter board.

   Position the eMMC

   

2. Press the eMMC firmly onto the formatter board to install it.

   Install the eMMC

   

Follow these steps to install the formatter cover.

1. Position the formatter cover (callout 1) on the printer, slide it toward the printer to install it, and then tighten one thumbscrew (callout 2).

   Install the formatter cover

   

Also use the following special installation instructions.