hp-support-head-portlet

Actions
Loading...
HP Customer Support - Knowledge Base

hp-contact-secondary-navigation-portlet

Actions
Loading...

hp-share-print-widget-portlet

Actions
Loading...
  • Information
    We are upgrading our website

    If you experience errors during this time, please try again later. 

hp-concentra-wrapper-portlet

Actions
Loading...

HP Color LaserJet Managed MFP E57540 - Load paper to Tray 1 (multipurpose tray)

Introduction

The following information describes how to load paper into Tray 1. This tray holds up to 100 sheets of 75 g/m2 paper or 10 envelopes.
note:
Select the correct paper type in the print driver before printing..
note:
Tray 1 does not support labels. To print on sheets of labels, use Tray 2, or one of the optional 550-sheet paper feeders.
  caution:
To avoid jams, never add or remove paper from Tray 1 during printing.
  1. Open Tray 1.
    Figure : Open Tray 1
  2. Pull out the tray extension to support the paper.
    Figure : Pull out the tray extension
  3. Spread the paper guides to the correct size, and then load paper in the tray. For information about how to orient the paper, see Tray 1 paper orientation.
    Figure : Load paper
  4. Make sure that the paper fits under the fill line on the paper guides.
    note:
    The maximum stack height is 10 mm, or approximately 100 sheets of 75g paper.
    Figure : Stack-height limit
  5. Adjust the side guides so that they lightly touch the paper stack, but do not bend it.
    Figure : Adjust the guides

Tray 1 paper orientation

When using paper that requires a specific orientation, load it according to the information in the following table.
note:
The Alternative Letterhead Mode settings affects the way to load letterhead or preprinted paper. This setting is disabled by default. When using this mode, load paper as for automatic duplex printing. For more information, see Use alternative letterhead mode.
Paper type
Image Orientation
Single-sided printing
Duplex printing or with Alternative Letterhead Mode enabled
Letterhead or preprinted
Portrait
Face-down
Top edge leading into the printer
Face-up
Bottom edge leading into the printer
Landscape
Face-down
Top edge toward the back of the printer
Face-up
Top edge toward the back of the printer
Prepunched
Portrait and landscape
Holes toward the back of the printer
Holes toward the back of the printer

Use alternative letterhead mode

Use the Alternative Letterhead Mode feature to load letterhead or preprinted paper into the tray the same way for all jobs, whether printing to one side of the sheet of paper or to both sides. When using this mode, load paper as for automatic duplex printing.
To use the feature, enable it by using the printer control-panel menus.

Enable Alternative Letterhead Mode by using the printer control-panel menus

  1. From the Home screen on the printer control panel, swipe from right to left until the Settings menu displays. Touch the Settings icon to open the menu.
  2. Open the following menus:
    • Manage Trays
    • Alternative Letterhead Mode
  3. Select Enabled, and then touch the Save button or press the OK button.

hp-feedback-input-portlet

Actions
Loading...

hp-feedback-banner-portlet

Actions
Loading...

hp-country-locator-portlet

Actions
Loading...
Country/Region: Flag Slovakia

hp-detect-load-my-device-portlet

Actions
Loading...