HP LaserJet Enterprise M607, M608, M609, M610, M611, M612, M612; HP LaserJet Managed E60055, E60065, E60075, E60155, E60165, E60175 - Removal and replacement: Tray 1 pickup roller

Follow these steps to remove the tray 1 pickup roller.

1. Do the following:

   • Open the tray 1.

   • Release two tabs (callout 1).

   • Remove the tray 1 pickup roller cover (callout 2).

   Release two tabs and remove the pickup roller cover

   

2. Do the following:

   • Release two tabs (callout 1).

   • Remove the tray 1 pickup roller (callout 2).

   Release two tabs and remove the pickup roller

   

Follow these steps to unpack the replacement assembly.

1. Dispose of the defective part.

   Note:

   HP recommends responsible disposal of the defective part.

   http://www8.hp.com/us/en/hp-information/environment/product-recycling.html

2. Unpack the replacement part from the packaging.

   CAUTION:

   Some parts are sensitive to electrostatic discharge (ESD). Always perform service work at an ESD-protected workstation or mat. If an ESD workstation or mat is not available, touch the sheet-metal chassis to provide a static ground before touching an ESD-sensitive assembly. Protect the ESD-sensitive assemblies by placing them in ESD pouches when they are out of the printer.

   Important:

   Make sure that all of the shipping materials (for example shipping tape) are removed from the replacement part prior to installation.

   Note:

   If the replacement part is a roller or pad, avoid touching the spongy part of it. Skin oils on the roller or pad can cause paper pickup and/or print-quality problems. HP recommends using disposable gloves when handling rollers or pads or washing your hands before touching rollers or pads.

3. To install an assembly, reverse the removal steps.

   Note:

   When applicable, special installation instructions are provided for an assembly at the end of the removal procedure. Always completely read the removal instructions and follow all special installation instructions.

Follow these steps to install the tray 1 pickup roller.

1. Do the following:

   • Hold open two tabs (callout 1).

   • Install the tray 1 pickup roller (callout 2).

   • Release two tabs (callout 1).

   Install the pickup roller and release two tabs

   

2. Do the following:

   • Install the tray 1 pickup roller cover (callout 2).

   • Close the two tabs (callout 1).

   • Close the tray 1.

   Install the pickup roller cover and close two tabs