HP LaserJet Enterprise M607, M608, M609, M610, M611, M612, M612; HP LaserJet Managed E60055, E60065, E60075, E60155, E60165, E60175 - Removal and replacement: Embedded multi-media card (eMMC)

Follow these steps to remove the formatter cover.

1. To remove the formatter cover, do the following:

   Note:

   A SFP printer is shown in this section. However, the procedure is correct for all printer models.

   • On the formatter cover, release two thumb screws (callout 1).

   • Slide the formatter cover in the direction indicated by the arrow (callout 2) and remove it.

   Release two thumb screws and remove the formatter cover

   

Follow these steps to remove the embedded multi-media card (eMMC).

1. Locate the eMMC component on the formatter, and then pull it straight off of the formatter to remove it.

   CAUTION:

   Electrostatic sensitive (ESD) parts. Always touch the sheet‑metal chassis to provide a static ground before touching an ESD‑sensitive part.

   Remove the eMMC component off of the formatter

   

Follow these steps to unpack the replacement assembly.

1. Dispose of the defective part.

   Note:

   HP recommends responsible disposal of the defective part.

   http://www8.hp.com/us/en/hp-information/environment/product-recycling.html

2. Unpack the replacement part from the packaging.

   CAUTION:

   Some parts are sensitive to electrostatic discharge (ESD). Always perform service work at an ESD-protected workstation or mat. If an ESD workstation or mat is not available, touch the sheet-metal chassis to provide a static ground before touching an ESD-sensitive assembly. Protect the ESD-sensitive assemblies by placing them in ESD pouches when they are out of the printer.

   Important:

   Make sure that all of the shipping materials (for example shipping tape) are removed from the replacement part prior to installation.

   Note:

   If the replacement part is a roller or pad, avoid touching the spongy part of it. Skin oils on the roller or pad can cause paper pickup and/or print-quality problems. HP recommends using disposable gloves when handling rollers or pads or washing your hands before touching rollers or pads.

3. To install an assembly, reverse the removal steps.

   Note:

   When applicable, special installation instructions are provided for an assembly at the end of the removal procedure. Always completely read the removal instructions and follow all special installation instructions.

Follow these steps to install the embedded multi-media card (eMMC).

1. Align the connector on the replacement eMMC (callout 1) with the connector on the formatter (callout 2).

   Note:

   The eMMC can only be installed in one direction on the formatter.

   Align the eMMC connector with the formatter connector

   

2. Push the eMMC onto the formatter to install it.

   Note:

   Press on the top part of the eMMC to ensure it is fully seated in the connector.

   Push the eMMC onto the formatter connector

   

Follow these steps to install the formatter cover.

1. Slide the formatter cover onto the printer in the direction indicated by the arrow (callout 1), and then tighten two thumb screws (callout 2).

   Note: An MFP printer is shown in this section. However, the procedure is correct for all printer models.

   Slide on the formatter cover and tighten two thumb screws