hp-support-head-portlet

Actions
Loading...

Welcome to HP Customer Support

hp-contact-secondary-navigation-portlet

Actions
Loading...

hp-share-print-widget-portlet

Actions
Loading...

hp-concentra-wrapper-portlet

Actions
Loading...

HP Designjet ColorPro Printers - Add Memory

Before installing memory
If you find that the amount of memory in your printer is insufficient for your requirements, you can install additional memory modules.
  caution:
Make sure the printer is turned off at the power isolator switch at the front of the printer, and that the power cord and the interface cable are disconnected.
  • The memory expansion module contains electrical components that are easily damaged by small amounts of static electricity. Please read the following information carefully before you handle the memory expansion module.
  • Leave the memory expansion module in the antistatic bag until you are ready to install it.
  • If possible, use an antistatic wrist strap and a grounding mat.
  • Before you remove the memory expansion module from the antistatic bag, touch a grounded, unpainted metal surface to discharge static electricity.
How to install memory
  1. Turn the printer off at the front of the printer and disconnect the power cord (at the side of the printer) and the interface cable (at the back).
  2. Release the two latches on either side of the back of the printer, so that the back hinges open down.
    Figure : Release the two latches on the back of the printer
  3. Put on a grounding wrist strap and attach the other end to the metal chassis of the printer.
    Figure : Put on a grounding wrist strap
  4. Unscrew the four screws and remove the cover plate at the back of the printer. To prevent loss of these screws, loosely re-install them in the printer.
    Figure : Unscrew the four screws and remove the cover plate
  5. Take the memory expansion module out of its bag. Hold the memory expansion module by its edges with the non-metallic edges toward you.
    Figure : Hold the module by its edges
  6. Carefully push the top edge of the memory expansion module into the slot.
  7. Continue pushing the top edge of the memory expansion module until you feel it “click” into position. At the same time, you will see that the top locking tab locks into position.
  8. Carefully push the bottom edge of the memory expansion module into the slot until you feel it “click” into position. Again, you will see the bottom locking tab lock into position.
  9. Remove the grounding wrist strap and re-install the cover plate on the back of the printer using the four screws.
  10. Reconnect the power cord and the interface cable, and then turn on the power isolator switch at the front of the printer.
  11. Replace the metal panel and close the back of the printer.

hp-feedback-input-portlet

Actions
Loading...

hp-online-communities-portlet

Actions
Loading...

Ask the community!


Support Forum

Support Forum

Join the conversation! Find Solutions, ask questions, and share advice with other HP product owners. Visit now


hp-feedback-banner-portlet

Actions
Loading...

hp-country-locator-portlet

Actions
Loading...
Country: Flag Slovenia

hp-detect-load-my-device-portlet

Actions
Loading...