
hp-support-head-portlet

- ${title}
hp-contact-secondary-navigation-portlet

- ${title}
hp-share-print-widget-portlet

- ${title}
hp-concentra-wrapper-portlet

- ${title}
HP LaserJet Enterprise 700 Color MFP M775 - Removal and replacement: ITB
This document provides the procedures to remove and replace the ITB.

Mean time to repair: 10 minutes
Service level: Basic
Before performing service
Turn the printer power off
-
Disconnect the power cable.
Warning:To avoid damage to the printer, turn the printer off, wait 30 seconds, and then remove the power cable before attempting to service the printer.
Use the table below to identify the correct part number for your printer. To order the part, go to www.hp.com/buy/parts.
Formatter kit number |
|
---|---|
CC522-67911 |
Kit, intermediate transfer belt (ITB) repair |
Required tools
-
#2 Phillips screwdriver with a magnetic tip.
After performing service
Turn the printer power on
-
Connect the power cable.
-
Use the power switch to turn the power on.
Post service test
Make sure that the printer initializes to a Ready state.
Print a configuration page to make sure that the printer is functioning correctly.
Remove the ITB
Follow these steps to remove the ITB.
Unpack the replacement assembly
Follow these steps to unpack the replacement assembly.
Replace the ITB
Follow these steps to replace the ITB.
hp-feedback-input-portlet

- ${title}
hp-feedback-banner-portlet

- ${title}
hp-country-locator-portlet

- ${title}

hp-detect-load-my-device-portlet

- ${title}
hp-hero-support-search

- ${title}