Служба поддержки клиентов HP - База знаний

hp-contact-secondary-navigation-portlet

Действия
Загрузка...
  • Информация

    Устраните проблемы с компьютерами и принтерами HP, связанные с обновлением Windows 10. Нажмите сюда

    Информация
    Создайте аккаунт HP уже сегодня!

     Получите быстрый доступ к материалам поддержки HP, управляйте устройствами в одном месте, ознакомьтесь с информацией о гарантии и многое другое. Узнать больше

HP Photosmart C3100 All-in-One Printer Series- Setting up the All-in-One (Hardware)

Introduction

This document explains how to set up the physical parts of the product. Complete these steps before you install the product software on your computer.
This document includes the following steps to set up the product:
  • Unpack the All-in-One
  • Check the contents of the box
  • Connect the power cord and adapter
  • Turn on power
  • Load plain paper
  • Install the cartridges

Setting up the All-in-One

Follow these steps in order.

Step one: Unpack the All-in-One

  1. Remove all tape and packing material from around the product.
  2. Lower the paper tray and remove all tape and packing material.
    Рис. : Lower the paper tray
  3. Lower the cartridge door and remove all tape and packing material.
    Рис. : Lower the cartridge door

Step two: Check the contents of the box

The contents might vary by country/region. See the packaging for a list of items shipped in the box.

Step three: Connect the power cord and adapter

  1. Connect the power cord to the product and the power adapter.
    Рис. : Connect the power cord and adapter
  2. Connect the power cord to the electrical outlet.

Step four: Turn on power

  1. Press the Power button ().
    Рис. : Press the Power button
  2. Wait 30 seconds for the product to start up.

Step five: Load plain paper

  1. Pull out the tray extender.
    Рис. : Pull out the tray extender
  2. Load plain, unused, white paper.
    Рис. : Load plain, unused, white paper

Step six: Install the cartridges

  1. Open the cartridge door. Make sure that the carriage moves to the right. If it does not move to the right, turn the product off and then turn it on again.
    Рис. : Open the cartridge door
  2. Remove the tape from both cartridges.
    Рис. : Remove the tape
      Внимание!
    Do not touch the copper-colored contacts or re-tape the print cartridges.
    Рис. : Copper-colored contacts
  3. Hold the cartridges with the HP logo on top.
  4. Insert the tri-color cartridge in the left slot and the black cartridge in the right slot.
    Рис. : Carriage slots
    Рис. : Insert the tri-color cartridge in the left slot
  5. Push the cartridges in firmly until they snap into place.
    Рис. : Push the cartridge in firmly
    Рис. : Tri-color cartridge and black cartridge correctly installed
  6. Close the cartridge door.
    Рис. : Close the cartridge door
    Примечание.
    Make sure that unused, plain, white paper is loaded in the paper tray, then wait a few minutes while the cartridge alignment page prints. Alignment is complete after the page prints.


Страна/регион: Flag Россия

hp-detect-load-my-device-portlet

Действия
Загрузка...