hp-support-head-portlet

Actions
Loading...
HP Customer Support - Knowledge Base

hp-contact-secondary-navigation-portlet

Actions
Loading...

hp-share-print-widget-portlet

Actions
Loading...
  • Information

    Audio or sound issues? Try our automated HP Audio check!

    Information

    Fix and resolve Windows 10 update issue on HP Computer or Printer. Click here

    Information
    Create an HP account today!

     Connect with HP support faster, manage all of your devices in one place, view warranty information and more. Learn more​

hp-concentra-wrapper-portlet

Actions
Loading...

HP LaserJet Pro M501, M506, MFP M527, HP LaserJet Managed E50045, E52545 - Removal and replacement: Tray 3

Introduction

This document provides the procedures to remove and replace Tray 3.

Before performing service

Turn the printer power off
  • Disconnect the power cable.
      warning:
    To avoid damage to the printer, turn the printer off, wait 30 seconds, and then remove the power cable before attempting to service the printer.
Use the table below to identify the correct part number for your printer. To order the part, go to www.hp.com/buy/parts.
Tray 3 part number
RM2-5758-000CN
Cassette (Tray 3) assembly

Required tools

  • No special tools are required to remove this part.

After performing service

Turn the printer power on
  • Connect the power cable.
  • Use the power switch to turn the power on.

Post service test

Make sure that the printer initializes to a Ready state.
Print a page from Tray 3 to make sure that the paper feeder is functioning correctly.

Step 1: Remove the tray

  1. Pull the tray straight out of the printer until it stops.
    Figure : Pull the tray out of the printer
  2. Slightly lift up on the front of the tray to release it, and then continue to pull the tray out of the accessory to remove it.
    Figure : Release and remove the tray

Step 2: Unpack the replacement tray

Unpack the replacement part from the packaging.
note:
HP recommends responsible disposal of the defective part.
Recycle and unpack
Figure : Recycle and unpack

Step 3: Install the tray

  1. With the tray at a slight angle, align the sides of the tray with the rails in the accessory, and then partially slide the tray into the accessory.
    Figure : Install the tray
  2. Push the tray straight into the accessory to close it.
    Figure : Close the tray

hp-feedback-input-portlet

Actions
Loading...

hp-feedback-banner-portlet

Actions
Loading...

hp-country-locator-portlet

Actions
Loading...
Country/Region: Flag Serbia

hp-detect-load-my-device-portlet

Actions
Loading...