This document applies to the HP Officejet Pro 6230 ePrinter.
To set up a printer for the first time, unpack the printer, connect the power cable, load paper in the main input tray, and then install the cartridges.
nota:When you pull out the input tray, one or all of the Paper Size Selection lights might blink. If you are changing the paper size, press the Paper Size Selection button (). Continue to press the button until the light displays next to your desired size.
atención:Failure to install the SETUP cartridges causes a cartridge error.
atención:Make sure that you remove the orange pull-tab and plastic wrap completely before you remove the orange cap in the next step. Otherwise, ink might leak from the cartridge. When you remove the plastic wrap, the paper label on the top of the cartridge tears slightly, which is necessary to properly vent the cartridge.
nota:You might need to apply some force to move the cap.
atención:Do not touch the copper-colored contacts or the ink nozzles. Touching these parts can result in clogs, ink failure, and bad electrical connections.