HP ScanJet Pro 2600 f1, 3600 f1, N4600 fnw1 / HP ScanJet Enterprise Flow N6600 fnw1 - Care and maintenance

Clean the scanner glass periodically, including any time dust or debris is present.

1. Press the Power button to turn off the scanner, and then disconnect the USB cable and power supply from the scanner.

2. Lift up the document feeder.

   

3. Use a clean, lint-free cloth moistened with water or spray the glass cleaner on a clean, lint-free cloth, and then thoroughly clean the flatbed scanner glass.

   CAUTION:

   Do not spray the glass cleaner directly on the scanner glass as this might cause permanent damage.

4. Dry the scanner glass with a dry, soft, lint-free cloth.

   Note:

   Make sure to dry the scanner glass completely.

5. Close the document feeder. Press the Power button to turn on the scanner. The scanner is now ready to use.

To clean the scanning strip components, follow these steps:

1. Press the Power button to turn off the scanner, and then disconnect the USB cable and power supply from the scanner.

2. Lift up the document feeder.

3. Clean the scanning strips with a soft, lint-free cloth that has been sprayed with a mild glass cleaner.

   
   CAUTION:

   Use only glass cleaner to clean the scanning strips. Avoid cleaners that contain abrasives, acetone, benzene, and carbon tetrachloride, all of which can damage the scanning strips. Avoid isopropyl alcohol because it can leave streaks on the scanning strips.

   Do not spray the glass cleaner directly on the scanning strips.

4. Dry the scanning strips with a dry, soft, lint-free cloth. Wipe the strips of gray, reflective material on each strip.

5. Close the document feeder, reconnect the USB cable and power supply to the scanner, and then press the Power button to turn on the scanner. The scanner is now ready to use.