hp-support-head-portlet
Actions
- ${title}
hp-contact-secondary-navigation-portlet
Actions
- ${title}
hp-share-print-widget-portlet
Actions
- ${title}
hp-concentra-wrapper-portlet
Actions
- ${title}
HP Color LaserJet MFP M577, MFP M578, MFP E57540 - Removal and replacement: Hardware Integration Pocket (HIP) cover (M577/M578/E57540)
Learn about removing and replacing the hardware Integration Pocket (HIP) cover.
Before performing service
Turn the printer power off
-
Disconnect the power cable.
Warning:To avoid damage to the printer, turn the printer off, wait 30 seconds, and then remove the power cord before attempting to service the printer.
To prevent damage to a toner cartridge, do not expose it to light for more than a few minutes. Cover the green imaging drum if the toner cartridge must be removed from the printer for an extended period of time.
If toner gets on the skin or clothing, wipe it off with dry tissue paper and wash in cold water. Hot water sets toner and it might be difficult, or impossible, to remove.
Use the table below to identify the correct part number for your printer, and then go to https://parts.hp.com/hpparts to order the part.
|
Part number |
Part description |
|---|---|
|
B5L46-40021 |
HIP cover |
Required tools
-
No special tools are required to remove or install this assembly.
After performing service
Turn the printer power on
-
Connect the power cable.
-
Use the power switch to turn the power on.
Post service test
No post service test is available for this assembly.
Remove the HIP cover
Follow these steps to remove the HIP cover.
-
Locate the HIP cover.
Locate the HIP cover
-
Use a small flat-blade screwdriver to release the tabs on the HIP cover.
Release the cover
-
Rotate the cover up and off of the printer to remove it.
Remove the cover
Unpack the replacement assembly
Follow these steps to unpack the replacement assembly.
-
Unpack the replacement part from the packaging.
CAUTION:Some parts are sensitive to electrostatic discharge (ESD). Always perform service work at an ESD-protected workstation or mat. If an ESD workstation or mat is not available, touch the sheet-metal chassis to provide a static ground before touching an ESD-sensitive assembly. Protect the ESD-sensitive assemblies by placing them in ESD pouches when they are out of the printer.
Important:Make sure that all of the shipping materials (for example shipping tape) are removed from the replacement part prior to installation.
Note:If the replacement part is a roller or pad, avoid touching the spongy part of it. Skin oils on the roller or pad can cause paper pickup and/or print-quality problems. HP recommends using disposable gloves when handling rollers or pads or washing your hands before touching rollers or pads.
Install the HIP cover
Follow these steps to remove the HIP cover.
-
Position the tabs (callout 1) on the HIP cover in the slots (callout 2) in the printer.
Position the cover
-
Rotate the cover down.
Note:Make sure that the tabs on the cover snap into place.
Install the cover
-
Make sure that the HIP cover is fully seated after installing it.
Check the installation
hp-feedback-input-portlet
Actions
- ${title}
hp-feedback-banner-portlet
Actions
- ${title}
hp-country-locator-portlet
Actions
- ${title}
New Zealand
hp-detect-load-my-device-portlet
Actions
- ${title}
hp-hero-support-search
Actions
- ${title}
