hp-support-head-portlet

Actions
Loading...
HP Customer Support - Knowledge Base

hp-contact-secondary-navigation-portlet

Actions
Loading...

hp-share-print-widget-portlet

Actions
Loading...

hp-concentra-wrapper-portlet

Actions
Loading...

Removing and Replacing the Battery for HP Pavilion dm1-4000, dm1-4100, dm1-4200, dm1-4300, and dm1-4400 Notebook PCs

This document applies to HP Pavilion dm1-4xxx series notebook computers.
-HP Pavilion dm1-4xxx series notebook computer

Before you begin

  • Turn off the computer. Disconnect the Ethernet or modem cable. Disconnect the power cord.
  • Transfer the computer to a clear, flat, stable work surface over a non-carpeted floor.
  • HP strongly recommends the use of an anti-static wrist strap and a conductive foam pad when working on the computer.
  • Do not remove a component from its protective packaging until you are ready to install it.
  warning:
The edges of metal panels can cut skin. Be careful not to slide skin along any interior metal edge of the computer.
  warning:
Before starting, power off the computer and wait for components to cool before starting these procedures.
  caution:
This product contains components that can be damaged by electrostatic discharge (ESD). To reduce the chance of ESD damage, work over a non-carpeted floor, use a static dissipative work surface (such as a conductive foam pad), and wear an ESD wrist strap connected to a grounded surface.

Video overview

View the following video before using the steps in this article.
note:
For best quality on dial-up connections, wait until the video has fully loaded before viewing.
note:
The video and graphics in this article depict a specific configuration of notebook computer. These same removal and replacement procedures apply to all configurations for all HP Pavilion dm1-4xxx Series PCs.

Removing the battery

  warning:
Make sure the computer is disconnected from power before starting.
Follow the steps in this section to remove the battery.
Step 1
On the bottom of the notebook, slide and hold the battery release latch into the release position to partially eject the battery.
Sliding the release latch
Step 2
Lift and remove the battery.
Removing the battery

Replacing the battery

Use the steps in this section to replace the battery.
Step 1
Align the bottom outer edge of the battery into the battery bay.
Aligning the battery
Step 2
Press down on the inner edge of the battery until it clicks into place.
Pressing down on  the battery

hp-feedback-input-portlet

Actions
Loading...

hp-feedback-banner-portlet

Actions
Loading...

hp-country-locator-portlet

Actions
Loading...
Country/Region: Flag New Zealand

hp-detect-load-my-device-portlet

Actions
Loading...