hp-support-head-portlet

Actions
Loading...
HP Customer Support - Knowledge Base

hp-contact-secondary-navigation-portlet

Actions
Loading...

hp-share-print-widget-portlet

Actions
Loading...

hp-concentra-wrapper-portlet

Actions
Loading...

HP EliteBook 6930p Notebook PC - Removing and Replacing the Upgrade Bay Device

Introduction

This document is provided to assist in removing and replacing the Upgrade Bay Device for the HP EliteBook 6930p Notebook PC.

Minimum skill level

The End User requires no hardware-specific training to replace the defective part. The End user should have familiarity with system hardware and software requiring repair.

Tools required

Small, Phillips-head P1 screwdriver.

Parts required

note:
Part numbers are subject to change.
The replacement part number will vary depending on the Upgrade Bay Device that is being replaced. If a part is listed as "Yes" under "Requires Return" then the defective part needs to be returned to HP. Click here for more information on returning parts to HP.
Description
Part Number
Requires Return
Upgrade bay device
502332-001 (Original)
No
note:
For customers in countries/regions with RoHS legislation* (e.g. EU, China, etc.) restricting the use of hazardous substances in electrical equipment. The use of the Original Spare part is regulated by RoHS legislation. If your unit contains a part that is labelled with the Modified Spare number, the Modified Spare must be ordered as the replacement part. If your unit contains a part that is labelled with the Original Spare number, please order the Original Spare as the replacement part. In this case either the Original Spare or the Modified Spare may be shipped which will not affect performance or functionality of the unit.

Summary of instructions

To view a video demonstrating the procedure for removing the Upgrade Bay Device, click on the link below. Or use the product video listing on the HP Services Media Library then select Upgrade Bay Device from the menu on the upper left hand side of the screen.
Click here to view the Upgrade Bay Device removal video (right-click on the link to open in a new window/tab).

Upgrade Bay Device removal

  1. Review the safety considerations before performing the steps listed below by clicking on the following link:
      caution:
    Failure to comply with the precautions could result in damage to your product or loss of data.
  2. Loosen the captive, spring-loaded P1 Phillips-head screw that secures the upgrade bay device to the base enclosure.
  3. Use a small, flat-bladed tool to push out on the metal tab on the rear of the upgrade bay device to partially eject it from the base enclosure.
  4. Grasp the upgrade bay device bezel and pull the upgrade bay device out of the base enclosure.

Upgrade Bay Device replacement

  1. Insert the upgrade bay device into the base enclosure until the connector is seated.
  2. Tighten the captive, spring-loaded P1 Phillips-head screw that secures the upgrade bay device to the base enclosure.

Parts return


hp-feedback-input-portlet

Actions
Loading...

hp-feedback-banner-portlet

Actions
Loading...

hp-country-locator-portlet

Actions
Loading...
Country/Region: Flag New Zealand

hp-detect-load-my-device-portlet

Actions
Loading...