hp-support-head-portlet

Handlinger
Laster inn...
HPs kundestøtte - kunnskapsbase

hp-contact-secondary-navigation-portlet

Handlinger
Laster inn...

hp-share-print-widget-portlet

Handlinger
Laster inn...

hp-concentra-wrapper-portlet

Handlinger
Laster inn...

HP Photosmart C4100 Series All-in-One - Installing Print Cartridges

Introduction

This document contains information about installing the print cartridges.

Installing the print cartridges

merknad:
The HP All-in-One must be powered on before you can insert the printcartridge.
  1. Place the unit flat on a level surface.
  2. Open the print cartridge door by lowering it until it stops. The print carriage moves to the far right side of the HP All-in-One.
    Figur : Print cartridge door and print carriage
  3. Pull the pink tab to remove the tape from the print cartridge.
    Figur : Removing the pink tab
      forsiktig:
    Donot touch or remove the ink nozzles orcopper-colored contacts, or re-tape thecartridges.
    Figur : Do not touch ink nozzles or copper-colored contacts
  4. Insert each print cartridge as follows:
    merknad:
    • Insert the tri-color print cartridge in the slot on the left side, marked with a green label.
    • Insert the black (or photo) print cartridge in the slot on the right side, marked with a black and orange label.
    1. Hold the print cartridge with the HP label facingup.
    2. Push the print cartridge firmly into the corresponding slot until it snaps intoplace.
      Figur : Inserting the print cartridge
      Figur : Print cartridges properly installed
  5. Close the access door.
    Figur : Access door being closed

hp-feedback-input-portlet

Handlinger
Laster inn...

hp-feedback-banner-portlet

Handlinger
Laster inn...

hp-country-locator-portlet

Handlinger
Laster inn...
Land/område: Flag Norge

hp-detect-load-my-device-portlet

Handlinger
Laster inn...