This document provides the procedures to remove and replace the document feeder reflector (MFP models only) (CSR A).
Mean time to repair: 10 minutes
Service level: Basic
When applicable, special installation instructions are provided for an assembly at the end of the removal procedure. Always completely read the removal instructions and follow all special installation instructions.
Turn the printer power off
Disconnect the power cable.
To avoid damage to the printer, turn the printer off, wait 30 seconds, and then remove the power cable before attempting to service the printer.
Use the table below to identify the correct part number for your printer. To order the part, go to www.hp.com/buy/parts.
Document feeder reflector part number |
|
---|---|
A7W94-67007 |
Document feeder reflector with instruction guide |
No special tools are required to remove or install this assembly.
Turn the printer power on
Connect the power cable.
Use the power switch to turn the power on.
Use the document feeder to make a copy.
Follow these steps to remove the document feeder reflector.
Follow these steps to unpack the replacement assembly.
Follow these steps to install the document feeder reflector.