HP LaserJet Managed MFP E826, E82650, E82660, E82670 - Load paper to Tray 2, Tray 3, and the optional 2 x 520-sheet trays

These trays hold up to 520 sheets of 75 grams per square meter (20 lb) paper.

Note:

The procedure to load paper to Tray 2, Tray 3, and the optional 2 x 520-sheet trays is the same. Only Tray 2 is shown here.

1. Open the tray.

   Note:

   Do not open any tray while it is in use.

   

2. Before loading paper, adjust the paper-width guides by holding down the blue lock/unlock toggle switch on the rear paper-width guide, pinching the blue adjustment latch on the front paper-width guide, and then sliding the guides to the fully open position.

   

3. Adjust the paper-length guide by pushing in at the bottom of the blue adjustment latch while sliding the guide to the size of the paper being used.

   

4. Load paper into the tray.

   

5. Adjust the paper-length and paper-width guides to the size of the paper being used. Check the paper to verify the guides lightly touch the stack, but do not bend it.

   Note:

   Do not adjust the paper guides tightly against the paper stack. Adjust them to the indentations or markings in the tray.

   Note:

   To prevent jams, adjust the paper guides to the correct size and do not overfill the tray. Be sure that the top of the stack is below the tray full indicator.

   

6. Close the tray.

   

7. The tray configuration message displays on the printer control panel.

8. Select OK to accept the detected type and size, or select Modify to choose a different paper size or type.

   For custom-size paper, specify the X and Y dimensions for the paper when the prompt displays on the printer control panel.