HP LaserJet Enterprise MFP M631, M632, M633, M634, M635, M636; HP LaserJet Managed MFP E62555, E62565, E62575, E62655, E62665, E62675 - Removal and replacement: Internal USB ports/AA module

Follow these steps to remove the formatter cover.

1. To remove the formatter cover, do the following:

   Note:

   A SFP printer is shown in this section. However, the procedure is correct for all printer models.

   • On the formatter cover, release two thumb screws (callout 1).

   • Slide the formatter cover in the direction indicated by the arrow (callout 2) and remove it.

   Release two thumb screws and remove the formatter cover

   

Follow these steps to install the USB ports/AA module.

1. From the internal USB ports/AA module accessory kit, obtain the following items:

   • The small PCA board.

   • The PCA mounting cradle.

   • The double-cable (B5L24–60106).

   Accesory kit items that are required

   

2. Locate the empty space in the upper right corner where the internal USB ports/AA module will be installed.

   Locate the space for installing the internal USB ports/AA module

   

3. Do the following:

   • Hold the small PCA and the PCA mounting cradle in the correct orientation.

   • Align the top and bottom cutouts of the PCA on the tabs of the PCA mounting cradle.

   • Secure the small PCA on the PCA mounting cradle until it snaps in place.

   Mount the PCA on the PCA mounting cradle and snap it in place

   

4. Attach the large white connector end of the double cable to the large connector receptacle on the small PCA board.

   Attach the large white connector to the PCA

   

5. Do the following:

   • Hold the small PCA attached to the PCA mounting cradle in the correct orientation, with the attached cable at the bottom.

   • In the upper right corner of the formatter cage area, locate the upper and lower sheet metal hooks.

   • Slide the assembly and mount it so that the upper and lower tabs of the PCA mounting cradle slide into the sheet metal hooks.

   Mount the assembly on the sheet metal hooks

   

6. On the formatter, disconnect the USB cable indicated by the arrow.

   Disconnect one formatter USB cable

   

7. Connect the USB cable (disconnected from the formatter) to the USB connector on the small PCA as indicated by the arrows.

   Note:

   The USB connector on the small PCA is to the left of where the white connector of the double-cable is installed.

   Connect the formatter USB cable to the small PCA

   

8. Connect the USB cable of the double-cable attached to the small PCA, to the USB connector on the formatter as indicated by the arrow.

   Connect the small PCA USB cable to the formatter USB connector

   

9. Connect the small white connector of the double-cable attached to the small PCA, to the matching connector near the upper right edge of the formatter as indicated by the arrow.

   Connect the small white connector from the small PCA to the formatter

   

Follow these steps to install the formatter cover.

1. Slide the formatter cover onto the printer in the direction indicated by the arrow (callout 1), and then tighten two thumb screws (callout 2).

   Note: An MFP printer is shown in this section. However, the procedure is correct for all printer models.

   Slide on the formatter cover and tighten two thumb screws