hp-support-head-portlet

Actions
Loading...
HP Customer Support - Knowledge Base

hp-contact-secondary-navigation-portlet

Actions
Loading...

hp-share-print-widget-portlet

Actions
Loading...
  • Information
    Learn how to upgrade to Windows 11

    Windows 11 Upgrade Guide

  • Feedback

hp-concentra-wrapper-portlet

Actions
Loading...

Samsung CLX-8380 Color Laser MFP - Loading Originals

This document provides instructions on how to load original documents into the printer. You can use the scanner glass or the dual automatic document feeder (DADF) to load an original for copying, scanning, and sending a fax.

Loading originals on the scanner glass

Make sure no originals are in the DADF. If an original is detected in the DADF, the printer gives it priority over the original on the scanner glass. To get the best scan quality, especially for colored or gray-scaled images, use the scanner glass.
To load an original onto the scanner glass, use the following steps.
  1. Open the scanner lid.
    Figure : Open the scanner lid
  2. Place the original face down on the scanner glass and align it with the registration guide at the top left corner of the glass.
    Figure : Align with registration guide
  3. Close the scanner lid.
    note:
    • Leaving the scanner lid open while copying may affect copy quality and toner consumption.
    • Dust on the scanner glass may cause black spots on the printout. Always keep it clean.
    • When copying a page from a book or magazine, lift the scanner lid until the hinges are caught by the stopper and then close the lid. If the book or magazine is thicker than 30 mm, start copying with the lid open.

Loading originals in the DADF

The DADF allows up to 100 sheets of paper (75 g/m2, 20 lb. bond) for one job.
When you use the DADF:
  • In the DADF: Do not load paper smaller than 69(W) x 145(L) mm (2.7 x 5.7 inches) or larger than 216(W) x 356(L) mm (8.5 x 14 inches).
  • Do not attempt to load the following types of paper:
    • carbon-paper or carbon-backed paper
    • coated paper
    • onion skin or thin paper
    • wrinkled or creased paper
    • curled or rolled paper
    • torn paper
  • Remove all staples and paper clips before loading.
  • Make sure any glue, ink, or correction fluid on the paper is completely dry before loading.
  • Do not load originals that include different sizes or weights of paper.
  • Do not load booklets, pamphlets, transparencies, or documents having other unusual characteristics.
To load an original into the DADF, use the following steps.
  1. Flex or fan the edge of the paper stack to separate the pages before loading originals.
    Figure : Fan or flex the paper
  2. Load the original face up in the DADF. Make sure the bottom of the original stack matches the paper size marked on the document input tray.
    Figure : Load original face up
  3. Adjust the document width guides to the paper size.
    Figure : Adjust the width guides
    note:
    Dust on the DADF glass may cause black streaks on the printout. Always keep it clean.

hp-feedback-input-portlet

Actions
Loading...

hp-feedback-banner-portlet

Actions
Loading...

hp-country-locator-portlet

Actions
Loading...
Country/Region: Flag Lithuania

hp-detect-load-my-device-portlet

Actions
Loading...