solution Contentsolution Content

HP Color LaserJet Enterprise M652, M653, Managed E65050, E65060, E65150, E65160 and HP Color LaserJet Enterprise MFP M681, M682, Managed MFP E67550, E67560, E67650, E67660 - Install accessory: Internal USB ports

Learn how to install the internal USB ports.

Mean time to repair: 5 minutes

Service level: Basic

Important:

When applicable, special installation instructions are provided for an assembly at the end of the removal procedure. Always completely read the removal instructions and follow all special installation instructions.

Before performing service

  • Disconnect the power cable.

    Warning:

    To avoid damage to the printer, turn the printer off, wait 30 seconds, and then remove the power cable before attempting to service the printer.

Use the table below to identify the correct part number for your printer. To order the part, go to www.hp.com/buy/parts

Part information

Part number

Part description

B5L28-67902

Two internal USB ports

Required tools

  • No special tools are needed to remove or install this assembly.

After performing service

Turn the printer power on

  • Connect the power cable.

  • Use the power switch to turn the power on.

Post service test

Make sure that the printer initializes to a Ready state.

Print a configuration page to make sure that the printer is functioning correctly.

Remove the formatter cover

Follow these steps to remove the formatter cover.

  1. Unscrew two thumbscrews (callout 1), and then slide the formatter cover (callout 2) away from the printer to remove it.

    Tip:

    Reverse the removal steps to install the assembly.

    Remove the formatter cover

    Remove the formatter cover

Remove the accessory from its package

Follow these steps to remove the accessory from its package.

  1. Save all packaging for recycling.

  2. For complete information about HP recycling programs, go to http://www8.hp.com/us/en/hp-information/environment/product-recycling.html.

Install the internal USB ports

Follow these steps to install the internal USB ports.

CAUTION:

ESD symbol ESD sensitive part.

Note:

The M682 is shown in the figures below. The procedure is also correct for the M681 and M652/M653 models.

  1. Remove the following items from the accessory kit:

    • The small PCA board

    • The PCA mounting cradle

    • The shortest single cable (B5L46-60115)

    Select accessory kit items

    Select accessory kit items

  2. Do the following:

    • Hold the small PCA and the PCA mounting cradle in the correct orientation.

    • Align the top and bottom cutouts of the PCA on the tabs of the PCA mounting cradle.

    • Secure the small PCA on the PCA mounting cradle until it snaps in place.

    Mount the PCA on the PCA mounting cradle and snap it in place

    Mount the PCA on the PCA mounting cradle and snap it in place

  3. Connect the cable to the small PCA.

    Connect the cable

    Connect the cable

  4. Do the following:

    • Hold the small PCA attached to the PCA mounting cradle in the correct orientation.

    • On the left side of the formatter case area, locate the sheet metal hooks.

    • Install the assembly so that the tabs on the PCA mounting cradle slide into the sheet metal hooks.

    Mount the assembly on the sheet metal hooks

    Mount the assembly on the sheet metal hooks

  5. Connect the cable to the formatter.

    Connect the cable

    Connect the cable

Install the formatter cover

Follow these steps to install the formatter cover.

  1. Slide the formatter cover (callout 1) toward the printer to install it, and then tighten two thumbscrews (callout 2).

    Install the formatter cover

    Install the formatter cover

Additional support options

Try one of our automated tools or diagnostics
Ask a question on our HP Support Community page
Get in touch with one of our support agents

Enter a topic to search our knowledge library

What can we help you with?