Samsung CLX-6200, CLX-6240 Laser MFP - Loading Originals

Make sure there are no originals are in the DADF (or ADF). If an original is detected in the DADF (or ADF), the printer gives it priority over the original on the scanner glass. To get the best scan quality, especially for colored or gray-scaled images, use the scanner glass.

To load originals on the scanner glass, use the following steps:

1. Lift and open the scanner lid.
   Figure : Example of lifting and opening the scanner lid

   
2. Place the original face down on the scanner glass and align it with the registration guide at the top left corner of the glass.
   Figure : Example of placing the original face down on scanner glass

   
3. Close the scanner lid.

   note:

   • Leaving the scanner lid open while copying may affect copy quality and toner consumption.
   • Dust on the scanner glass may cause black spots on the printout. Always keep it clean.
   • If you are copying a page from a book or magazine, lift the scanner lid until its hinges are caught by the stopper and then close the lid. If the book or magazine is thicker than 30 mm, start copying with the lid open.

Using the DADF (or ADF), you can load up to 50 sheets of paper (75 g/m2, 20 lb bond) for one job.

note:

• In the ADF: Do not load paper smaller than 142 x 148 mm (5.6 x 5.8 inches) or larger than 216 x 356 mm (8.5 x 14 inches).
• In the DADF: Do not load paper smaller than 148 x 148 mm (5.8 x 5.8 inches) or larger than 216 x 356 mm (8.5 x 14 inches).
• Do not attempt to load the following types of paper:
  • carbon-paper or carbon-backed paper
  • coated paper
  • onion skin or thin paper
  • wrinkled or creased paper
  • curled or rolled paper
  • torn paper
• Remove all staples and paper clips before loading.
• Make sure any glue, ink, or correction fluid on the paper is completely dry before loading.
• Do not load originals that include different sizes or weights of paper.
• Do not load booklets, pamphlets, transparencies, or documents having other unusual characteristics.

To load originals in the DADF (ADF), use the following steps:

1. Flex or fan the edge of the paper stack to separate the pages before loading originals.
   Figure : Example of flexing or fanning paper

   
2. Load the original face up into the DADF (or ADF). Make sure that the bottom of the original stack matches the paper size marked on the document input tray.
   Figure : Example of loading the original face up in the DADF (ADF)

   
3. Adjust the document width guides to the paper size.
   Figure : Example of adjust the document width guides

   

   note:

   Dust on the DADF (or ADF) glass may cause black lines on the printout. Always keep it clean.