HP Designjet 111 Printer Series - Load paper from the input tray

note:

The input tray has two feet that must rest on the table.

1. Remove the input tray.
   
2. Lift up the tray cover.
   
3. If the paper you are using is larger than Legal- or A4-size, move the small tab in the center towards the left so that you can lengthen the tray. Let go of the tab and pull the tray extension out as far as it will go.
   
4. Riffle the paper. This helps to prevent adjacent sheets of paper from sticking to each other.
   
5. Slide the paper into the tray under the tray cover, ensuring that it touches the sides of the tray on the right and on the printer side.
   
6. Push in the small tab on the right of the tray so that it fits snugly against the paper. Move the larger tab on the left of the tray so that it too fits snugly against the paper.
   
7. Close the tray cover.
8. Lift up the output tray and insert the input tray into the printer, keeping it straight and pushing it in as far as it will go. The left inside corner must be aligned with the plastic paper tray guide.
9. Lower the output tray. Note that, if the input tray is extended, it will extend out beyond the output tray.