Error:

В браузере отключена поддержка Javascript. Для этой страницы требуется поддержка Javascript. Включите поддержку Javascript в браузере. Инструкции приведены в документации к браузеру.

hp-support-head-portlet

Действия

Загрузка...

Служба поддержки клиентов HP - База знаний

hp-contact-secondary-navigation-portlet

Действия

Загрузка...

hp-share-print-widget-portlet

Действия

Загрузка...

Информация

Узнайте, как перейти на Windows 11
Руководство по обновлению Windows 11

Оставить отзыв

hp-concentra-wrapper-portlet

Действия

Загрузка...

HP Photosmart C3100 All-in-One Printer Series- Setting up the All-in-One (Hardware)

Introduction

This document explains how to set up the physical parts of the product. Complete these steps before you install the product software on your computer.

This document includes the following steps to set up the product:

Unpack the All-in-One
Check the contents of the box
Connect the power cord and adapter
Turn on power
Load plain paper
Install the cartridges

Setting up the All-in-One

Follow these steps in order.

Step one: Unpack the All-in-One

Remove all tape and packing material from around the product.
Lower the paper tray and remove all tape and packing material.

Рис. : Lower the paper tray
Lower the cartridge door and remove all tape and packing material.

Рис. : Lower the cartridge door

Step two: Check the contents of the box

The contents might vary by country/region. See the packaging for a list of items shipped in the box.

Step three: Connect the power cord and adapter

Connect the power cord to the product and the power adapter.

Рис. : Connect the power cord and adapter
Connect the power cord to the electrical outlet.

Step four: Turn on power

Press the Power button ().

Рис. : Press the Power button
Wait 30 seconds for the product to start up.

Step five: Load plain paper

Pull out the tray extender.

Рис. : Pull out the tray extender
Load plain, unused, white paper.

Рис. : Load plain, unused, white paper

Step six: Install the cartridges

Open the cartridge door. Make sure that the carriage moves to the right. If it does not move to the right, turn the product off and then turn it on again.

Рис. : Open the cartridge door
Remove the tape from both cartridges.
Рис. : Remove the tape

Внимание!
Do not touch the copper-colored contacts or re-tape the print cartridges.
Рис. : Copper-colored contacts
Hold the cartridges with the HP logo on top.
Insert the tri-color cartridge in the left slot and the black cartridge in the right slot.

Рис. : Carriage slots

Рис. : Insert the tri-color cartridge in the left slot
Push the cartridges in firmly until they snap into place.
Рис. : Push the cartridge in firmly

Рис. : Tri-color cartridge and black cartridge correctly installed
Close the cartridge door.
Рис. : Close the cartridge door

Примечание.
Make sure that unused, plain, white paper is loaded in the paper tray, then wait a few minutes while the cartridge alignment page prints. Alignment is complete after the page prints.