hp-support-head-portlet

조치
로드 중...
HP 고객 지원 - 지식 기반

hp-contact-secondary-navigation-portlet

조치
로드 중...

hp-share-print-widget-portlet

조치
로드 중...
  • 정보
    Windows 11로 업그레이드하는 방법 알아보기

    Windows 11 업그레이드 설명서

    정보

    HP 컴퓨터 또는 프린터에서 Windows 10 업데이트 문제를 수정하고 해결합니다. 여기를 클릭하세요

  • 피드백

hp-concentra-wrapper-portlet

조치
로드 중...

HP Deskjet 460 series - Installing the Print Cartridges

Introduction

This document contains information about installing the print cartridges.
This document applies to the following printers: HP Deskjet 460, 460c, 460cb, 460wbt, and 460wf.

Install the print cartridges

  1. Remove the new print cartridge from its package and then pull the colored tab to remove the protective film from the cartridge.
    사진 : Removing the print cartridge from its package
  2. With the printer turned on, open the front access cover. Wait for the carriage to stop moving. This should take only a few seconds.
      경고:
    Only remove or install print cartridges when the print cartridge carriage stops moving.
    사진 : Open the front access cover
  3. Lift the print cartridge latch open and gently remove the print cartridge from its cradle compartment.
    사진 : Lifting the print cartridge latch
  4. Insert the new print cartridge into its cradle compartment at the same angle at which you removed the old print cartridge. Check the number on the latch against the number on the print cartridge to make sure you are inserting the correct print cartridge.
    사진 : Inserting the new print cartridge
  5. Close the print cartridge latch. If the cartridge is inserted correctly, closing the latch gently pushes the cartridge into its cradle compartment. Press the latch to make sure it is seated flat on the cartridge.
    사진 : Closing the cartridge latch
  6. Close the front access cover.
  7. Wait for the carriage to complete the print cartridge initialization routine and return to the home position at the left side of the printer before using the printer.
주의:
Do not open the front access cover until the print cartridge initialization is complete.

hp-feedback-input-portlet

조치
로드 중...

hp-feedback-banner-portlet

조치
로드 중...

hp-country-locator-portlet

조치
로드 중...
국가/지역: Flag 한국

hp-detect-load-my-device-portlet

조치
로드 중...