HP LaserJet MFP M631, M632, M633, M634, M635, M636, M637, E62555, E62565, E62575, E62655, E62665, E62675 - Removal and replacement: Fuser

Follow these steps to remove the fuser.

1. Do one of the following to locate the fuser:

   • : Open the rear door.

   • : Open the right door.

     Warning:

     The fuser might be hot. Always wait for the fuser to cool before removing.

   Open the rear door or open the right door

   

2. Hold the handles of the fuser and pull it out of the printer to remove it.

   Remove the fuser

   

Follow these steps to unpack the replacement assembly.

1. Dispose of the defective part.

   Note:

   HP recommends responsible disposal of the defective part.

   http://www8.hp.com/us/en/hp-information/environment/product-recycling.html

2. Unpack the replacement part from the packaging.

   CAUTION:

   Some parts are sensitive to electrostatic discharge (ESD). Always perform service work at an ESD-protected workstation or mat. If an ESD workstation or mat is not available, touch the sheet-metal chassis to provide a static ground before touching an ESD-sensitive assembly. Protect the ESD-sensitive assemblies by placing them in ESD pouches when they are out of the printer.

   Important:

   Make sure that all of the shipping materials (for example shipping tape) are removed from the replacement part prior to installation.

   Note:

   If the replacement part is a roller or pad, avoid touching the spongy part of it. Skin oils on the roller or pad can cause paper pickup and/or print-quality problems. HP recommends using disposable gloves when handling rollers or pads or washing your hands before touching rollers or pads.

3. To install an assembly, reverse the removal steps.

   Note:

   When applicable, special installation instructions are provided for an assembly at the end of the removal procedure. Always completely read the removal instructions and follow all special installation instructions.

Follow these steps to install the fuser.

1. Hold the handles of the fuser and install it into the printer in the direction indicated by the arrow.

   Install the fuser

   

2. Do one of the following:

   • : Close the rear door.

   • : Close the right door.

   Close the rear door or close the right door