This document provides the procedure to install the optional printer stand accessory on any of the following printers:
-
HP Color LaserJet Enterprise M751
-
HP Color LaserJet Enterprise MFP M776
-
HP Color LaserJet Enterprise M856
-
HP Color LaserJet Managed E75245
-
HP Color LaserJet Managed E85055
note:One or two optional 550-sheet paper trays can be installed on top of the printer stand. The number of optional 550-sheet trays that can be installed depends on the printer model. Refer to the printer user guide for more information.
-
Take the printer stand accessory out of the box, and then remove the packaging material. Verify that the contents match this illustration:
note:
HP recommends recycling packing materials whenever possible.Figure : Contents of the box -
Press the Power button to turn off the printer.Figure : Turn off the printer
-
Disconnect the power cord and the USB cable or network cable.Figure : Disconnect the cables
-
Open the door on the front of the printer stand and turn the latch (located in the top-right corner) counterclockwise to unlock it.Figure : Open the door and unlock the latch
-
Place the printer on top of the printer stand. If you are also installing optional 550-sheet trays, place the optional trays on top of the printer stand first, and then place the printer on top of the optional tray(s).
caution:
Due to the weight of the printer, HP recommends that four people move the printer to place it on top of the printer stand (or the optional 550-sheet tray).warning:
Back surface may not align on all models. The M856 and E85055 are larger than the accessory. Align the front surface and not the rear of the printer.Figure : Place the printer on top of the printer stand -
Make sure the door is open on the printer stand and then turn the latch (located in the top-right corner) clockwise to lock the printer to the stand.Figure : Turn the latch on the stand clockwise to lock the printer to the stand
-
Close the door on the printer stand.Figure : Close the door on the printer stand
-
Reconnect the power cable to the outlet and the printer, and then connect the USB or network cable.Figure : Reconnect the cables
-
Press the Power button to turn on the printer.
-
Remove the stabilizing feet from the box.Figure : Unpack the stabilizing feet
-
Open the door on the front of the printer stand.Figure : Open the door on the printer stand
-
Insert the stabilizing feet into the slots on the bottom front and sides of the printer stand.Figure : Install the stabilizing feet
-
Make sure the stabilizing feet are installed securely in the slots. The stabilizers will click into place when installed securely.Figure : Make sure the stabilizing feet click into place
-
Close the door on the front of the printer stand.Figure : Close the door on the printer stand