hp-support-head-portlet

Actions
Loading...
HP Customer Support - Knowledge Base

hp-contact-secondary-navigation-portlet

Actions
Loading...

hp-share-print-widget-portlet

Actions
Loading...
  • Information
    Apache Log4j Update

    Please see this document here for current information regarding the Apache Log4j vulnerability.

    Information
    Need Windows 11 help?

    Check documents and videos on compatibility, FAQs, upgrade information and available fixes. Windows 11 Support Center

  • Feedback

hp-concentra-wrapper-portlet

Actions
Loading...

HP Latex 3000 Printer Series - Replace the printhead cleaning roll

Replace the printhead cleaning roll

  1. Any unused portion of the roll is wound on to the takeup roll at this time. You will be warned if the unused portion is more than 5% of the whole roll.
  2. In order to replace the printhead cleaning roll, unlock and open the door on the front right of the printer.
  3. Grip the handle and pull the whole printhead cleaning roll assembly out through the door.
  4. Pull the black knob on the upper left and move the pinch system aside.
  5. Clean the rubber blade with the end of the roll.
  6. Slide both rolls off their axles and dispose of the roll with the used cleaning material according to the instructions provided with the new roll. Also consult your local authorities to determine the correct manner in which to dispose of wastes. Keep the empty core to use as a takeup core.
  7. Slide the new roll onto the upper axle.
  8. Insert the upper axle, placing the end cap on the side, and slide it all together until you hear a click.
  9. Pass the leading edge of the roll over the upper rollers, and thread the cleaning material through the rollers on the left.
  10. There is a strip of polyester film on the leading edge of the cleaning material. Insert it into the hole in the takeup core, which takes hold of it.
  11. Slide the takeup core onto the lower axle.
    note:
    If the cleaner roll has not been properly installed, you may see a message about clearing a printhead cleaning roll jam. Pull the whole assembly out, wind a little of the roll forward, then slide it back in again. The printer will check the roll again
  12. Restore the pinch system by moving the black knob back into place. If you feel resistance because the cleaning roll is too tight, turn the roll slightly counter-clockwise.
    note:
    There is a green ring on the far side of the black knob, which should not be visible if the knob has been correctly placed. If it is visible, try again.
  13. Grip the handle and push the whole printhead cleaning roll assembly back into the printer. Ensure that you push it as far as it will go.
  14. Close and lock the door.
  15. Click Finish in the wizard window.
The printhead cleaning roll length tracking is now reset to zero.
note:
If you tamper with half-used rolls, the usage shown in the Internal Print Server will not be accurate.
Do not empty or remove the drain container: this is done by a service engineer during preventive maintenance.

hp-feedback-input-portlet

Actions
Loading...

hp-feedback-banner-portlet

Actions
Loading...

hp-country-locator-portlet

Actions
Loading...
Country/Region: Flag Ireland

hp-detect-load-my-device-portlet

Actions
Loading...