Error:

Javascript is disabled in this browser. This page requires Javascript. Modify your browser's settings to allow Javascript to execute. See your browser's documentation for specific instructions.

hp-support-head-portlet

Actions

HP Customer Support - Knowledge Base

hp-contact-secondary-navigation-portlet

Actions

hp-share-print-widget-portlet

Actions

hp-concentra-wrapper-portlet

Actions

HP Compaq Business Notebook nc6000 Series - Power Cord Requirements

Three-conductor power cord

General requirements

Country/region-specific requirements

Three-conductor power cord

The wide range input feature of the notebook permits it to operate from any line voltage from 100 to 120 or 220 to 240 volts AC.

The power cord included with the notebook meets the requirements for use in the country/region where the equipment is purchased.

Power cords for use in other countries/regions must meet the requirements of the country/region where the notebook is used. For more information on power cord requirements, contact an HP authorized reseller or service provider.

General requirements

The requirements listed below are applicable to all countries/regions:

The length of the power cord must be at least 1.5 meters (5.00 feet) and a maximum of 2.0 meters (6.50 feet).
All power cords must be approved by an acceptable accredited agency responsible for evaluation in the country/region where the power cord will be used.
The power cord must have a minimum current capacity of 10 amps and a nominal voltage rating of 125 or 250 volts AC, as required by each country's/region's power system.
The appliance coupler must meet the mechanical configuration of an EN 60 320/IEC 320 Standard Sheet C13 connector for mating with the appliance inlet on the back of the notebook.

Country/region-specific requirements

Country/region	Accredited Agency	Note
Australia	EANSW	The flexible cord must be <HAR> Type HO5VV-F, 3-conductor, 1.0 mm2 conductor size. Power cord fittings (appliance coupler and wall plug) must bear the certification mark of the agency responsible for evaluation in the country/region where it will be used.
Austria	OVE	The flexible cord must be <HAR> Type HO5VV-F, three-conductor, 1.0 mm2 conductor size. Power cord fittings (appliance coupler and wall plug) must bear the certification mark of the agency responsible for evaluation in the country/region where it will be used.
Belgium	CEBC	The flexible cord must be <HAR> Type HO5VV-F, three-conductor, 1.0 mm2 conductor size. Power cord fittings (appliance coupler and wall plug) must bear the certification mark of the agency responsible for evaluation in the country/region where it will be used.
Canada	CSA	The flexible cord must be Type SPT-3 or equivalent, No. 18 AWG, 3-conductor. The wall plug must be a two-pole grounding type with a NEMA 5-15P (15 A, 125 V) or NEMA 6-15P (15 A, 250 V) configuration.
Denmark	DEMKO	The flexible cord must be <HAR> Type HO5VV-F, three-conductor, 1.0 mm2 conductor size. Power cord fittings (appliance coupler and wall plug) must bear the certification mark of the agency responsible for evaluation in the country/region where it will be used.
Finland	FIMKO	The flexible cord must be <HAR> Type HO5VV-F, three-conductor, 1.0 mm2 conductor size. Power cord fittings (appliance coupler and wall plug) must bear the certification mark of the agency responsible for evaluation in the country/region where it will be used.
France	UTE	The flexible cord must be <HAR> Type HO5VV-F, three-conductor, 1.0 mm2 conductor size. Power cord fittings (appliance coupler and wall plug) must bear the certification mark of the agency responsible for evaluation in the country/region where it will be used.
Germany	VDE	The flexible cord must be <HAR> Type HO5VV-F, three-conductor, 1.0 mm2 conductor size. Power cord fittings (appliance coupler and wall plug) must bear the certification mark of the agency responsible for evaluation in the country/region where it will be used.
Italy	IMQ	The flexible cord must be <HAR> Type HO5VV-F, three-conductor, 1.0 mm2 conductor size. Power cord fittings (appliance coupler and wall plug) must bear the certification mark of the agency responsible for evaluation in the country/reigon where it will be used.
Japan	METI	The appliance coupler, flexible cord, and wall plug must bear a "T" mark and registration number in accordance with the Japanese Dentori Law. The flexible cord must be Type VCT or VCTF, three-conductor, 1.00 mm2 conductor size. The wall plug must be a two-pole grounding type with a Japanese Industrial Standard C8303 (7 A, 125 V) configuration.
The Netherlands	KEMA	The flexible cord must be <HAR> Type HO5VV-F, three-conductor, 1.0 mm2 conductor size. Power cord fittings (appliance coupler and wall plug) must bear the certification mark of the agency responsible for evaluation in the country/region where it will be used.
Norway	NEMKO	The flexible cord must be <HAR> Type HO5VV-F, three-conductor, 1.0 mm2 conductor size. Power cord fittings (appliance coupler and wall plug) must bear the certification mark of the agency responsible for evaluation in the country/region where it will be used.
Sweden	SEMKO	The flexible cord must be <HAR> Type HO5VV-F, three-conductor, 1.0 mm2 conductor size. Power cord fittings (appliance coupler and wall plug) must bear the certification mark of the agency responsible for evaluation in the country/region where it will be used.
Switzerland	SEV	The flexible cord must be <HAR> Type HO5VV-F, three-conductor, 1.0 mm2 conductor size. Power cord fittings (appliance coupler and wall plug) must bear the certification mark of the agency responsible for evaluation in the country/region where it will be used.
United Kingdom	BSI	The flexible cord must be <HAR> Type HO5VV-F, three-conductor, 1.0 mm2 conductor size. Power cord fittings (appliance coupler and wall plug) must bear the certification mark of the agency responsible for evaluation in the country/region where it will be used.
United States	UL	The flexible cord must be Type SPT-3 or equivalent, No. 18 AWG, three-conductor. The wall plug must be a two-pole grounding type with a NEMA 5-15P (15 A, 125 V) or NEMA 6-15P (15 A, 250 V) configuration.

hp-feedback-input-portlet

Actions

hp-feedback-banner-portlet

Actions

hp-country-locator-portlet

Actions

Country/Region: Flag

Ireland

hp-detect-load-my-device-portlet

Actions

hp-hero-support-search

Actions

Examples: "LaserJet Pro M252 paper jam", "ProBook 440 G2 bios update"