hp-support-head-portlet

- ${title}
hp-contact-secondary-navigation-portlet

- ${title}
hp-share-print-widget-portlet

- ${title}
hp-concentra-wrapper-portlet

- ${title}
Removal and replacement: Control-panel assembly (M806, M855)
This document provides the procedures to remove and replace the control panel for the HP LaserJet Enterprise M806 and HP Color LaserJet Enterprise Flow M855.
Mean time to repair: 5 minutes
Service level: Basic
Before performing service
Turn the printer power off
-
Disconnect the power cable.
Warning:To avoid damage to the printer, turn the printer off, wait 30 seconds, and then remove the power cord before attempting to service the printer.
Use the table below to identify the correct part number for your printer. To order the part, go to www.hp.com/buy/parts.
Control panel kit part number |
|
---|---|
5851-5950 |
Control panel kit with instruction guide |
Required tools
-
No special tools are required to install this kit.
After performing service
Turn the printer power on
-
Connect the power cable.
-
Use the power switch to turn the power on.
Post service test
Print a configuration page to make sure that the printer is functioning correctly.
Remove the control-panel assembly (M806)
Follow these steps to remove the control-panel assembly (M806).
These steps apply only to the M806 models. For the M830 models, skip to the next step.
Unpack the replacement assembly
Follow these steps to unpack the replacement assembly.
Install the control-panel assembly
Follow these steps to install the control-panel assembly.
hp-feedback-input-portlet

- ${title}
hp-feedback-banner-portlet

- ${title}
hp-country-locator-portlet

- ${title}

hp-detect-load-my-device-portlet

- ${title}
hp-hero-support-search

- ${title}