For the HP Designjet Entry level printers, the customers can purchase the network card or Jet Direct Network card for network connectivity. This is an accessory to provide connectivity to the HP Designjet Entry Level printers. The LAN card is inserted into a slot in the Electronics Module at the rear of the printer.
To guide the customer to insert the LAN Card into the correct slot, the Electronics Module now comes with the LAN Slot engraved with the words LAN and a symbol indicating LAN.
If the network card is installed correctly, the printer will print three pages while printing the information page.
Follow the HP Designjet 100, 110, 120 and 130 Series Printers - Utilities and Test Prints From Front Control Panel web page for the document containing the procedure for printing the information page.
note:
Copy and paste the above link in the address line of your Web browser.
The I/O section will look like as follows:
Also, under Information Page, num of I/O cards present : 1 shows that the network card is present as shown in the figure below:
If the network card is not installed correctly, the printer will not print the I/O section as mentioned above and the information page will display num I/O cards present : 0.